User manual PYLE PWD103 SYSTEM MANUAL

[. . . ] · The dome light will turn on. * * Optional Feature. NOTE:Transmitter cosmetics may differ, but button functions remain the same. NOTE: If the optional two-step unlock feature is installed, pressing button 2 will unlock only the driver's door. Press button 2 again to unlock all remaining doors. 1 853 new. qxd 3/15/2004 12:44 PM Page 2 PASSIVE STARTER DEFEAT If the optional starter defeat is installed, the system can be programmed to automatically disable the starter 45 seconds after turning off the ignition as an extra measure of security in the event the vehicle is accidentally left unlocked. During the 45 second countdown, the LED will flash rapidly to indicate the passive starter defeat sequence has begun. After 45 seconds, the LED will flash slowly and the vehicle's starter will be disabled. [. . . ] · WHITE WIRE - Parking light output (+). Connect to the wire that shows +12V when the parking lights are on. If the vehicle's parking light circuit exceeds 10A, a relay is · BLACK WIRE - Ground input (-). Connect to a solid chassis ground that is clean and free required. For vehicle's with independent left and right parking light circuits, the parking light wires must be connected using diodes to keep the circuits separate. · WIRE - Unlock #87 normally open input 10A fuse. (see Door Lock Wiring Diagrams) · BLUE/BLACK WIRE - Unlock #30 common output. (see Door Lock Wiring Diagrams) · BROWN/BLACK WIRE - Unlock #87A normally closed input. (see Door Lock Wiring Diagrams) · VIOLET/BLACK WIRE - Lock #87 normally open input 10A fuse. (see Door Lock Wiring Diagrams) · GREEN/BLACK WIRE - Lock #30 common output. (see Door Lock Wiring Diagrams) · WHITE/BLACK WIRE - Lock #87A normally closed input. (see Door Lock Wiring Diagrams) · ORANGE WIRE - Armed Output (-) 500Ma. The ORANGE wire provides ground when the unit is armed to activate a starter disable relay. (See Relay Wiring Diagrams) · BLACK/YELLOW - Dome light output (-) 500mA. Connect to a relay to activate the dome light when the system is unlocked. (See Relay Wiring Diagrams) · GRAY WIRE - Auxiliary output (-) 500mA. Connect to a relay for optional trunk release etc. (See Relay Wiring Diagrams) · BROWN WIRE - Horn honk output (-) 500mA. Connect to a relay to honk the vehicle's horn. (See Relay Wiring Diagrams) 3 853 new. qxd 3/15/2004 12:44 PM Page 4 · BLUE/WHITE WIRE - Passenger unlock output (-) 500mA. The BLUE/WHITE wire provides a ground to unlock the passenger doors when the unlock button on the transmitter is pressed two times. To install the two-step unlock feature, the BLUE/BLACK and BROWN/BLACK wires must be run directly to the driver's door actuator unlock wire and the BLUE/WHITE wire must be connected to a relay to unlock the passenger doors. [. . . ] · The horn will provide a long chirp, to indicate entering program mode. Press transmitter button 3. The LED will flash 3 times, pause then continue flashing. All programmable features will be reset to the default position. ADDING / DELETING REMOTE TRANSMITTERS Adding new transmitters to the system will automatically delete all other remotes that were previously operating the system. [. . . ]