User manual PYLE PWD250 SYSTEM MANUAL

[. . . ] VEHICLE SECURITY SYSTEM Optional Remote Start Module and 2-way Transmitter Instructions Included SYSTEM MANUAL Button 1 STANDARD FEATURES Some of the system's standard features include: · 4-button remote transmitter · LED Status indicator · Valet switch · Extended Range Receiver · 125dB Multi-tone siren · Dual stage impact detector · Remote panic · Remote Valet mode · Remote chirp delete · Remote sensor bypass · Passive or active arming · Flashing parking lights · Auto Rearming OPTIONAL FEATURES This system has many optional features that may require additional parts and/or labor. Please contact your dealer for more details. · Remote keyless entry (door lock/unlock) · Illuminated entry · LCD 2-way Remote · Hood & trunk protection · Trunk/hatch release · Window roll-up · Additional sensors · Remote Start (optional plug-in module) · Stop & Go Feature · Auto Cold Start Note: Some features may not be appropriate for certain vehicles. 1 REMOTE TRANSMITTER BUTTONS Button 2 Button 3 Button 4 Transmitter Icons NOTE: Transmitter cosmetics may differ between models and between standard 1-way and LCD 2-way transmitters, but button functions remain the same as described below. [. . . ] See Alarm Programmable Features Dome Light (default): Connect to a relay to activate the vehicle's dome light. The dome light relay output is usually connected to the same wire used for the door trigger input (See BLUE/RED and BLUE/BLACK wires). Window Roll-up: Connect to a relay or other 13 device to operate window modules or other desired features. · BLACK/RED WIRE - Starter defeat/anti-grind output (-) 500mA. The BLACK/RED wire is terminated beside the small YELLOW ignition jumper in a 2-pin connector for the supplied starter defeat relay socket. Connect the relay socket for starter defeat (and anti-grind protection with optional remote start module connected). The starter defeat output is programmable for normally open or normally closed operation. See Starter Defeat Relay Diagrams and Alarm Programmable Features · ORANGE/VIOLET WIRE - Brake switch input wire. Connect this wire to the brake switch wire that provides +12V when the brake pedal is pressed. This safety input must be connected when used with the optional remote start module or the remote start feature will not operate. If the remote start module is not connected, leave this wire disconnected and set Alarm Programmable Feature #3 to either button 2, 3 or 4 setting. See Alarm Programmable Features · BLUE/RED WIRE - Positive door trigger (+). Connect to the door switch circuit wire that shows +12V when the door is open. This type of door circuit is usually found on Ford vehicles. · ORANGE/WHITE WIRE - Trunk trigger (-). Connect to an optional trunk pin switch that shows ground when the trunk is open. · GREEN/BLACK WIRE - Parking Light output (+) 10A relay. Connect to the vehicle's parking light wire. If the vehicle's parking light circuit exceeds 10 Amps a relay is required. For vehicle's with independent left and right parking light circuits, connect the GREEN/BLACK wire to one side and the GREEN/YELLOW wire to the other. NOTE: Do not connect the GREEN/BLACK or GREEN/YELLOW wire to the vehicle's headlight circuit. · GREEN/YELLOW WIRE - Parking Light output (+/-) 10A relay. Used for vehicle's with independent left and right parking light circuits; see GREEN/BLACK wire. [. . . ] This system requires use of a tiny passive transmitter housed in the base of the key. This device activates when placed close to the vehicle's ignition switch. The starter will usually crank but the fuel system will be disabled, not allowing the vehicle to run, if the transponder is not detected. To properly 20 interface i n t o transponder systems, a transponder bypass module must be installed. [. . . ]