User manual PYLE PWMA230

[. . . ] Protect the Disc Mechanism Avoid inserting any foreign objects into the slot of this player. Failure to observe this may cause malfunction due to the precise mechanism of this unit. Use Authorized Service Centres Do not attempt to disassemble or adjust this precision product. Please refer to the Service Centre list included with this product for service assistance. [. . . ] Each band stores up to six preset stations. The stations might be FM1, FM2, FM3, AM1 and AM2 band. The operation is as below: - Store in Memory Press and hold desired memory 20 PROGRAM PXXX During the playback, use to or skip an item ahead or back. : Rapid reverse, : Rapid advance Note: The FOLDER cannot be selected during playing. It can be selected after (STOP) button pressed. OPERATION location button for several seconds. The current listening station will be stored into the number button. - Retrieve a Preset Station Press any one of the RADIO PRESET buttons (1~6) on remote control to retrieve a station which had been stored in the memory in advance the chosen number is shown on display. · Automatic memory storing & program scanning - Program scanning Press GOTO (AS/PS) button on remote control shortly to scan preset station. And it will hold at each station for about 5 seconds. - Automatic memory storing Press GOTO (AS/PS) button on remote control for several seconds, the radio searches from the current frequency and checks the signal strength until one cycle search is finished. And then stations are stored into the preset number button in turn according to the strength of stations. The corresponding value will show on the display. AV OPERATION · Switching to AV mode On the back of the unit, there is a pair of AUDIO/VIDEO INPUT jacks. When you connect an audio/video system through these jacks, press MODE button on remote control to select AV mode. · Menu Control operation in AV mode Press SEL button on remote control to enter sound menu, then you can press CH / buttons to select the item upward or downward. Then press VOL+/- buttons to adjust the selected item. The corresponding value will show on the display. VOLUME BASS TREBLE BALANCE FADER LOUD EQ 40 -2 -2 L-R R-F ON POP VOLUME BASS TREBLE BALANCE FADER LOUD EQ 40 -2 -2 L-R R-F ON POP · Mute Press MUTE button on remote control to cut down sound output. Press it again to resume the previous volume mode. RGB OPERATION · Switching to RGB mode When you connect the RGB terminals on the back of the DVD unit to the corresponding RGB system, then press MODE button on remote control to select RGB mode, the RGB signal will appear on the screen. Note: When you press MODE button to select RGB mode and there hasn't any RGB signal input, then there is nothing to display on the screen. 22 SETUP INITIAL SETUP SETUP MENU --- MAIN PAGE GENERAL SETUP SPEAKER SETUP AUDIO SETUP PREFERENCES GENERAL SETUP --- GENERAL PAGE --TV DISPLAY PIC MODE ANGLE MARK OSD LANG CAPTIONS SCR SAVER NORMAL / PS NORMAL / LB WIDE EXIT SETUP 1. Press SETUP on the remote control in the stop mode. (Press the button twice to ensure that the player is in under STOP mode. ) 2. Select the preferred item by using the / buttons. GENERAL SETUP This setup page includes all the item of TV display & Audio output feature. For details please refer to GENERAL SETUP MENU. [. . . ] High temperature can shorten the life of electronic devices, damage batteries, and distort or melt plastic parts. For Tape Player Periodic cleaning of the tape head and capstan shaft will ensure good reproduction of music and trouble-free operation. Cleaning of the tape head should be done every 20 to 30 hours of operation or when the high tones have become less clear. Use a cassette-cleaning cartridge if available. [. . . ]