User manual PYLE PYX3X

[. . . ] Electronic Crossover Network Please complete warranty card, detach and return Thank you for purchasing this PYLE product. To activate your warranty, please mail this card within 10 days. warranty registration card Name Address City, State ZIP PYLE PRO ELECTRONICS Model No. Date of Purchase Purchased at: Music Products Store Catalog Merchandiser Serial # (if available) Sound Contractor/Installer Other Mail Order Owner's Manual PYX-3X Your new Pyle Pro PYX-3X Electronic Crossover Network is designed to enable the home stereo audiophile to install a biamp, triamp or multi-amp system with extreme ease, while still allowing for the sophisticated settings a high end installation demands. [. . . ] A similar system can be built using separate amplifiers to handle the two frequency ranges. This kind of setup would be accomplished as follows: Lower end, HIGHS range: 5KHz Upper end, MIDS range: 5KHz Lower end, MIDS/HIGHS range: 120Hz Upper end, LOWS range: 120Hz AMP CH 1 + 2 INPUTS AMP CH 3 + 4 INPUTS (HIGHS CHANNEL) (MIDS CHANNEL) 4 CH AMPLIFIER CD PLAYER, TAPE PLAYER RADIO TUNER Note: Only LOWS and MIDS output jacks are used for connections in a biamp installation! NOTE: These diagrams show hookups using the RCA type jacks, but you can use the 1/4" jacks instead with similar results. FUSE INPUT HIGH OUTPUT MID INPUT LOW HIGH OUTPUT MID LOW L L L L R R INPUT HIGH OUTPUT MID INPUT LOW HIGH OUTPUT MID R R FUSE LOW L L L L R HIGH OUTPUTS MID OUTPUTS SUBWOOFER AMP INPUTS (LOWS CHANNEL) 2 CH AMPLIFIER R R R Input connections using 1/4" jacks AMP CH 1 + 2 INPUTS (MIDS/HIGHS CHANNEL) AMP CH 3 + 4 INPUTS (LOWS CHANNEL) 4 CH AMPLIFIER LOW OUTPUTS MID/HIGH OUTPUTS LOW OUTPUTS 2 ­ PYLE PRO PYX-3X Electronic Crossover Network Owner's Manual PYLE PRO PYX-3X Electronic Crossover Network Owner's Manual - 3 Please complete warranty card, detach and return Mounting the PYX-3X The PYX-3X is designed to accept standard rack mounting installations. Two slots on each end of the front panel make it suitable for such an installation. Tightly secure four mounting screws (not supplied) through these fours slots and into your standard electronics equipment rack. Crossover Frequencies Low 50, 90, 180. 360 and 720 Hz Mid (High Pass) 50, 90, 180. 360, 720 Hz and Flat Mid (Low Pass) 1K, 2K, 4K, 6K, 8KHz and Flat High 1K, 2K, 4K, 6K and 8KHz Filter Slope Total Harmonic Distortion Frequency Response S/N Ratio Power Requirement Power Consumption Dimensions, inches (mm) -12dB/Octave <0. 01% 20 Hz - 20KHz (+/- 0. 5 dB) 90 dB AC 110V/60Hz or 230V/50Hz 6W 18 7/8 x 2 3/8 x 7 7/8 (180 x 60 x 200) Turning the PYX-3X on 1. Turn on the audio input source equipment which is connected to the PYX-3X INPUT jacks. Set the LOW, MID and HIGH volume level controls to their minimum level settings. Adjust the crossover frequency points to suit your audio system installation. Push in the power switch to turn the amplifier on. Adjust the LOW, MID and HIGH volume level controls to the desired volumes. Limited Warranty All PYLE PRO products are carefully constructed and tested before shipment. Units purchased in the USA are warranted to be free of defects in material and workmanship for two (2) years from the date of purchase. This warranty is limited to the original retail purchaser of the amplifier. Should the unit fail due to factory defects in material or workmanship, your unit will be repaired or replaced at the sole discretion of PYLE. To obtain warranty service, you must first call our Consumer Return Hotline at (718) 236-6948 to obtain a Return Authorization Number. # must appear on the outside of your package and on all paperwork relating to your return. [. . . ] Replace the fuse compartment cap. 4 ­ PYLE PRO PYX-3X Electronic Crossover Network Owner's Manual PYLE PRO PYX-3X Electronic Crossover Network Owner's Manual - 5 PYLE PRO Audio, Inc. 1600 63rd Street Brooklyn, NY 11204 Connecting to standard AC power After making all other connections, set the POWER switch to OFF position. Then connect the power cord to a standard AC outlet. PYX-3X Specifications Input Impedance >47 K-Ohms Place Stamp Here [. . . ]