User manual PYRAMID PR332T

[. . . ] Make sure not to confuse the left and right cables in connection. FM antenna Indoor T-shaped FM antenna The T-shaped antenna included with the unit meant for temporary use unit an outdoor is set up. [. . . ] TUNER DISPLAY The frequency of the station which has been in is indicated in digits. MHz units are used for FM frequencies and KHz units for AM frequencies. When the MEMORY SCAN switch or the PRESET STATION switch is pressed, the current station number will be displayed. * When the MEMORY SCAN switch (in remote handset) is pressed, the memorized preset number will flash, and change approximately every 5 seconds. Press the memory hold (in remote handset) switch to stop at the desired station. * The number which was last displayed before power was turned off will be displayed again when power is turned back on. TUNING SWITCH (UP or DOWN) Press UP or DOWN to search your favourite station. Tuning can be performed either automatically or manually, depending on the setting of the tuning mode selector switch. Auto tuning: When the DOWN TUNING switch is depressed, the frequency which is tuned in is counted down and this countdown operation stops automatically as soon as the station is tuned in the LOCK indicator together with the relative frequencies will be continuously counted down without stopping when stations are tuned in until you release the switch. This will stop the automatic tuning operation when the lower frequency limit is reached, count-down changes over to count-up. Manual tuning: Every time one of the TUNING switches is depressed, the received frequency moves up or down in 50Khz units for FM and 9 KHz for AM. When the switches are kept in the depressed position, the received frequency moves up and down rapidly in the units you release the switches. [. . . ] PRESET STATION SWITCHES Up to 20 AM or FM stations may be preset at random. Presetting the switches will allow you to tune in your favourite stations simply and easily. SPECIFICATIONS FM Section Tuning range. . . . . . . . . . . . . . . . . . . . . . 87. 5 to 108 MHz Usable Sensitivity Mono IHF. . . . . . . . . . . . . . . . . . . . . . . 12 dB (3. 9 uv) 50 dB quieting sensitivity Mono. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16. 5 dBf Stereo. . . . . . . . . . . . . . . . . . . . . . . . . . . . 37. 0 dBf Signal to noise ratio at 65 dBf Mono. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 dB Stereo. . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 dB Distortion at 65 dBf Mono. . . . . . . . . . . . . . . . . . . . . . . . . . . . . less than 0. 15% at 1, 000Hz Stereo. . . . . . . . . . . . . . . . . . . . . . . . . . . . . less than 0. 2% at 1, 000Hz Alternate channel selectivity (at 400 KHz). . . . . . . . . . . . . . . . . . . . . . 30 dB Stereo separation. . . . . . . . . . . . . . . . 40 dB at 1, 000 Hz Frequency response. . . . . . . . . . . . . 40 to 14 KHz +3. 0 dB, -3. 0 dB Antenna input impedance. . . . . 300 ohms balanced 75 ohms unbalanced AM (MW) Section Tuning range. . . . . . . . . . . . . . . . . . . . . . . . MW: 530 to 1710KHz Usable sensitivity. . . . . . . . . . . . . . . . . . MW: 68 dB/m (446uVm) Signal to noise ratio. . . . . . . . . . . . . . . . 40 dB Image response ratio. . . . . . . . . . . . . . . MW: 40 dB at 1, 000kHz Others Output voltage and impedance. . . 220 mV/2. 2kohms Power requirements Power voltage. . . . . . . . . . . . . . . . . . . . 220V~50Hz For U. K. . . . . . . . . . . . . . . . . . . . . . . . . . . 240V~50Hz For U. S. A & Canada. . . . . . . . . . . . 110V~ 60Hz Power consumption. . . . . . . . . . . . [. . . ]