User manual PYRAMID PR530A

[. . . ] Locations which are unstable and not perfectly flat or which are susceptible to vibration. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARMING: To prevent fire or shock hazard, do not expose this appliance to rain or moisture Do not wipe with thinners Wipe the panels and case from time to time with a soft cloth. Using any kind of thinner, alcohol or volatile liquid will mar the surface, cause blotching on the exterior and erase the markings and should therefore be avoided. Do not use insecticide sprays in the vicinity. [. . . ] Adjust the volume so that it does not hurt your ears when using the headphones. - If you do not intend to use your headphones, always ensure that you unplug them. REMOTE STANDBY INDICATOR The Power Amplifier is in remote standby state if the remote standby indicator is lighted. MUTE Press this switch to mute the sound, press it again to cancel the mute function. VOLUME LEVEL DISPLAY Press this switch to see the volume level indicated by INDICATOR DISPLAY. 4 OPERATING PROCEDURES Before starting operation Check that the controls have been set to the following positions before commencing operation Rotate the VOLUME control counterclockwise as far as it will go and set it at the "0" minimum volume position. Set the BALANCE control to its center position. Set the BASS and TREBLE tone controls to the "0" (center) position. After these checks, press the POWER switch to turn on the power. If you find a remote standby indicator is lighted, the power amplifier is in remote standby mode. (a) Press the power switch off and press it once again after the remote standby indicator is off. (b) Using the remote control to switch on the power. After switching on, the indicator will be shinning on "Phono" for a second, after that the unit is set to "Tuner". Playing a program source 1. Press the desired input selector switch to select the program source to which you wish to listen. To listen to record: press the PHONO switch. To listen to radio broadcast: Press the TUNER switch. To listen to a compact disc: Press the CD switch. To listen to a component connected to VIDEO terminals: Press the VIDEO switch. To listen to a component connected to AUX terminals: Press the AUX switch. To listen to a tape: Press the TAPE switch. 3. Gradually turn the VOLUME control clockwise until the desired volume level is obtained. 4. Attain a balance between the sound of the left and right channels using the BALANCE control. 5. To adjust the tone quality, adjust the BASS and TREBLE control. [. . . ] Press again can resume to playback time display. (P. S: This key only works with our CD of our HI-FI system. ) REMOTE CONTROL UNIT Remote controlling instructions The remote control box can directly control majority of system functions of HI-FI SYSTEM. The functions include power control of the whole system, Volume control, sound field control, CD operation control, Tuner operation control and also source control function. This remote controller may not function properly if an obstacle is located between it and the receiving unit, or if the remote controller is held at an improper angle with respect to the receiving unit. Battery Installation Remove the rear cover of the remote controller by sliding it backward. [. . . ]