User manual QSC AUDIO WL212-SWV BROCHURE

[. . . ] Frequently these venues have height or sightline restrictions that limit the placement and size of the array. Rising fuel costs are putting pressure on touring system providers to downsize their transportation requirements. At the same time, client and audience expectations for audio performance has never been higher. [. . . ] The extremely low profile of the WL212-sw sub (less than 15") also makes it a great choice for installed and portable use under a stage or in other tight quarters. The 4th order bandpass design matches the width of the WideLine-8 elements allowing it to be flown inline with or behind a WideLine-8 array. Premium materials are used throughout the system. The enclosure is constructed of Baltic birch plywood and coated in an environmentally friendly, waterborne polymer finish that is field repairable. To keep the weight to a minimum and prevent rust, suspension fittings are made of aluminum. An elegantly simple 4-point suspension system combined with light weight, compact size and excellent handling ergonomics mean that a one person crew can easily deploy an array. A single AF3082-L array frame suspends up to twelve line array elements or up to twelve line array elements plus four subwoofers. The WideLine-8 system is equally at home in the air or ground-stacked. Special attention is given to ground-stacked applications. The WideLine-8 sub suspension system includes a unique provision that allows the lowest line array element stacked over a sub to be tilted up or down by as much as 10º, offering better coverage of listeners near the stage. WideLine-8 subs may be used as a base for stacking up to six WideLine-8 elements. WideLine-8 Flexible Arrays System Configurations Arrays can be assembled using only WL3082 line arrays modules, with WL212-sw subwoofers at the top of the array, or by utilizing the EB3082 extension bar, subwoofers can be flown behind the main array. Arrays of up to twelve WL3082 modules, with four WL212-sw subwoofers flown behind can be accommodated by the combination of 2 x AF3082-S small array frames and a single EB3082 extension bar (Figure A). As many as twelve WL3082 modules can be suspended using one AF3082-S (Figure B) while the AF3082-L large array frame can be used to assemble arrays of up to 12 x WL3082 modules alone or suspended below up to 4 x WL212-sw subwoofers (Figure C). The AF8-10 adapter frame (not shown) allows the user to add WL3082 WideLine-8 arrays beneath WL2012 WideLine-10 arrays. The PB3082 pullback bar (not shown) can be used to attain extra down-angle in flown arrays or as a suspension bar for arrays of up to eight WL3082 modules. Figure A Figure B Figure C -10º 0º +10º Optimized Ground Stacking WideLine-8 rigging doubles as an optimized ground stacking system. Using the WL212-sw subwoofer as a base, arrays of WL3082 line array elements can be aimed downward by as much as ten degrees to cover audience areas close to a stage, as well as upward by as much as ten degrees in order to better cover distant balcony seating areas. Specifications | Signal Processing WL3082 Configuration Transducers High-frequency Low-frequency Frequency Response (±3 dB) Frequency Range (-10 dB) Nominal Impedance 3" diaphragm, neodymium magnet compression driver Dual, 8" woofer, 2. 5" voice coil 68 Hz ­ 18 kHz 62 Hz ­ 20 kHz HF: 16 MF: 16 LF: 16 HF: 85 W MF: 250 W LF: 250 W HF: 108 dB SPL MF: 98 dB SPL LF: 98 dB SPL HF: 127 dB SPL / 133 dB SPL MF: 122 dB SPL / 128 dB SPL LF: 122 dB SPL / 128 dB SPL H: 140° V: dependent on number of elements used Ported, trapezoidal 15 mm birch plywood Available in black (WL3082) or white (WL3082-WH) paintable Perforated, 16AWG steel, backed with black/white cloth fabric 2 x NL8 in parallel 1+/1- NC; 2+/2- LF; 3+/3- MF; 4+/4- HF Integral, side plate adjustable rigging system, vertical splay adjustable in 1° increments from 0° ­ 10° 38 lb (17 kg) / 45. 5 lb (20. 7 kg) 9" x 20" x 16" 229 mm x 508 mm x 406 mm AF3082-S · AF3082-L · EB3082 · CP3082 · PB3082 · AF8-10 -- Dual, 12" woofer with a 4" voice coil, ceramic magnet assembly 40 Hz ­ 100 Hz 32 Hz ­ 107 Hz Dual 8", 3-way, tri-amp line-array WL212-sw Dual 12", 4th order bandpass subwoofer SUB: 4 Continuous Power Capacity1 LF: 1100 W Sensitivity (1 W at 1 m) LF: 99 dB SPL Maximum Output, Continuous / Peak (dB SPL at 1 m) Nominal Coverage Enclosure Type Enclosure Material Finish Grille Connectors Pin Outs Attachment Points Weight (Net / Shipping) Dimensions (HWD) Available Accessories See descriptions on back LF: 129 dB SPL / 135 dB SPL -- -- 4th order bandpass 15 mm birch plywood Available in black (WL212-sw) or white (WL212-sw-WH) paintable - 2 x NL8 in parallel 1+/1- Sub; 2+/2- NC; 3+/3- NC; 4+/4- NC Integral, non-adjustable 109 lb (49. 4 kg) / 125 lb (56. 7 kg) 15" x 20" x 29" 381 mm x 508 mm x 737 mm AF3082-L · CP212 · AF3082-S 1) 2 hours, IEC specified noise Specifications subject to change without notice. WideLine-8 Signal Processing The WL3082 is designed for tri-amplification. [. . . ] QSC, the QSC logo, WideLine and BASIS are registered trademarks of QSC Audio Products, LLC in the U. S. Patent and Trademark office and other countries. Intrinsic Correction is a trademark of QSC Audio Products, LLC. [. . . ]