User manual QUAD 33

[. . . ] Sociedad Unipersonal reserves the right to introduce any modifications it considers suitable, without prior notice. This is how you can contribute to preserving the environment. The way you ride determines your fuel consumption and therefore how much your motorcycle pollutes the atmosphere. In the same way, the way you treat your moped affects its noise level and wear and tear on the vehicle. [. . . ] Never drive the vehicle with the helmet on your side, this could be very dangerous. It is strictly forbidden to perform changes that modify the features of the vehicle, because any alteration of it´s structure parts can change the features, and besides that it is illegal, the vehicle will not fit the homologation type approved, and it will become dangerous when you drive it. Aditional loadings In case that the vehicle has to carry aditional loads, it is indispensable to follow the rules that are indicated below: 1. The aditional loads must be placed near the driver and at the center of gravity of the vehicle as much as possible. If these are not properly placed, or if they are too big, the enter of gravity can change and this will be dangerous for your safety and the handling operations. Make sure that there is enough free space between the bank angle and the road. Remember that incorrect attachments can result in an unproperly balanced weight, and will cause you to loose the stability of your vehicle. Shifting gear Close the throttle, pull the clutch lever and put the shift pedal into any gear you wish to run. If you need to reduce the speed, select a shorter gear. To performed the maintenance, use the tools given in the specific tool box provided. The engine oil quality is the main factor to obtain the best results for the features designed in the vehicle and, therefore, it is important to follow the indications and operations described in the PROGRAMMED MAINTENANCE chart. 2) - During the installation, insert the spark plug with the necessary bank angle and tighten it with you hands. The spark plug must be removed with the cold engine. the circuit of the brake fluid is dangerous. In case of accidental contact, clean immediately with water the affected parts. Make sure there is no leakage in the circuit and check that the hoses and the unions are not damaged and also they shoul not be twisted. The adjustment of the brake pump has been done at the factory; if necessary, go to your nearest Dealer QUAD. It is forbidden to change these adjustments, because it can seriously damage the brake system. The brake circuit fluid is highly corrosive, avoid contact with the body, painted parts and / or any plastic parts. If the moisture of the brake fluid is higher than its specified value, the brakes will not work properly. Under normal weather conditions, the brake fluid must be replaced every 2 years. For this operation which needs an special care, go to your nearest Dealer QUAD. [. . . ] Then, wash the body properly and dry it with a chamois leather. If you would like to make it shinny with silicon waxes, the vehicle must be washed firstly. The vehicle in areas where the water can be recollected and purified. The vehicle needs to be clean · Never use a high pressure jet of water, it can damage all the electrical devices. [. . . ]