User manual QUANTUM 642300204A01

[. . . ] ATL M-Series User's Guide 6423002-04 A01 ATL M-Series User's Guide, 6423002-04 A01, September 2003, Made in USA. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice. COPYRIGHT STATEMENT Copyright 2003 by Quantum Corporation. [. . . ] 6 To return to the Configuration screen without changing the option setting, press Cancel. 7 Press Main to return to the main screen. Changing the Illumination Setting 3 The Illumination option allows you to turn the interior illumination of the library on or off. This illumination allows you to view the robotics easily through the viewing window. To enable or disable Illumination: 1 Access the Configuration screen (see Accessing the Configuration Screen on page 49). 2 Press the Up or Down buttons until Illumination is highlighted. 4 Use the Up or Down buttons to select the desired Illumination setting. The available settings are Enabled and Disabled. Note: The default setting is Enabled. ATL M-Series User's Guide 59 Chapter 3 Changing the Library Configuration Changing the Off-Line Time Setting 5 Press Select. To return to the Configuration screen without changing the option setting, press Cancel. 6 Press Main to return to the main screen. Changing the Off-Line Time Setting 3 When you access the Menu screen using the GUI, the library becomes NOT READY and will not respond to any SCSI commands issued. If you leave the library unattended in menu mode, the library goes back to a READY state after a pre-set time-out, controlled by the Off-Line Time option. You can set this time-out to any value from 1 to 99 minutes, or turn it off. To set the Off-Line Time: 1 Access the Configuration screen (see Accessing the Configuration Screen on page 49). 2 Press the Up or Down buttons until Off-Line Time is highlighted. 4 Use the Up or Down buttons to select the desired Off-Line Time setting. The available settings are 1 through 99 and Disabled. Note: The default setting is Disabled. 5 Press Select. To return to the Configuration screen without changing the option setting, press Cancel. 6 Press Main to return to the main screen. 60 ATL M-Series User's Guide Chapter 3 Changing the Library Configuration Changing the Barcode Scanner Setting Changing the Barcode Scanner Setting 3 The Barcode Scanner option controls whether the bar code scanner is enabled or disabled. When the scanner is enabled, the library attempts to detect a bar code on all tape cartridge labels. If the correct bar code labels are not used, or if some cartridges are not labeled, scanning time may be greatly increased. Therefore, it is recommended that you disable the Barcode Scanner option if you do not intend to use compatible bar code labels. [. . . ] Gränserna är utformade att tillhandahålla rimligt skydd mot störningar när utrustningen används i en kommersiell miljö. Utrustningen alstrar, använder och kan utstråla radiofrekvent energi och kan, om den ej installeras och används i enlighet med instruktionshandboken, orsaka störningar i radiokommunikation. Eventuella ändringar eller modifikationer av utrustningen kan ogiltigförklara användarens rätt att använda utrustningen. ATL M-Series User's Guide 181 Appendix D Regulatory Statements Användning av utrustningen i bostadsområden kan orsaka störningar och i sådana fall måste användaren bekosta de åtgärder som krävs för att åtgärda störningarna. Enheten uppfyller del 15 i FCC-reglerna. [. . . ]