User manual QUANTUM 818120902

[. . . ] Using the Rack Mount Kit To Install the DLT Rack1 Chassis in an Equipment Rack Step 1 Remove the chassis members from the slides and attach the chassis members to the chassis. Use (4) M3 × 4 mm pan-head PHILLIPS® screws. [. . . ] b. Step 4 Align the slides: Open and close the slides twice, making sure the chassis sections engage in the cabinet sections properly and that the locks function properly. Securely tighten the front bracket screws onto the slide. a. Information in this document is subject to change without notice. Copyright © 2003, 2004 by Quantum Corporation. Reproduction in any manner without the prior written permsision of Quantum Corporation is strictly prohibited. Trademarks: Quantum is a trademark of Quantum Corporation, registered in the U. S. A. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Quantum Corporation disclaims any proprietary interest in trademarks and trade names other than its own. Part Number 81-81209-02 Rev A01 *81-81209-02* Using the Rack Mount Kit To Install the DLT Rack2 Chassis in an Equipment Rack Step 1 Remove the chassis members from the slides and attach the chassis members to the chassis. Use (6) M3 × 4 mm pan-head PHILLIPS® screws. See Figure 1. Chassis member Chassis Chassis member Figure 1 Step 2 Loosely mount the left and right cabinet section/bracket assemblies into the rack between the upright rails (see Figure 2). [. . . ] b. Step 4 Align the slides: Open and close the slides twice, making sure the chassis sections engage in the cabinet sections properly and that the locks function properly. Securely tighten the front bracket screws onto the slide. a. [. . . ]