User manual QUANTUM 818126401A01

[. . . ] Though the components are similar in appearance, many component parts are not interchangeable. These include the magazines, cartridges, drive carrier assembly, magazine blank, magazine handle, and the bar code reader. For additional information, visit www. quantum. com, refer to the Quantum Superloader Automated Tape Library User Manual installed as a PDF (portable document format) file on the SuperLoader Documentation CD, or contact Quantum Technical Support and Customer Service by calling 1-800-284-5101. [. . . ] Rotate the DCA so that the other foam pad is up. The DCA should still be inside antistatic packaging. Caution: This device is static-sensitive. Proper grounding and electrostatic discharge (ESD) handling precautions are required before removing the DCA from its packaging. These precautions include unpacking the DCA in a static-free work area and using an antistatic wrist band as well as other antistatic apparel. Set the DCA down on the work surface. Step 2: Prepare for Removal and Replacement Caution: Do not apply power to the DCA unless the DCA is fully installed in the SuperLoader and secured by all four mounting screws. Make sure you have the following tools: · #2 PHILLIPS® screwdriver b. Leave the replacement DCA in its antistatic packaging until you are ready to install it. SuperLoader Drive Carrier Assembly (DCA) Replacement Quick Start Guide Page 2 Step 3: Remove the Current DCA Note: Before you remove the DCA, make sure the tape drive does not contain a tape cartridge. For instructions about unloading a cartridge from the tape drive, refer to the User's Guide. Turn off the SuperLoader using the front panel button. Disconnect all cables from the back of the DCA. Remove the four screws that secure the DCA to the chassis at the rear of the SuperLoader. e. Note: The DCA must be returned to Quantum in the replacement DCA packaging within 7 business days. For further information, refer to the return material authorization (RMA) instructions shipped with the replacement DCA. Step 4: Install the Replacement DCA Caution: While removing or handling the SuperLoader DLT DCA, take appropriate ESD precautions to prevent accidentally touching or damaging the exposed printed circuit board assembly on the underside of the unit. Remove the replacement DCA from its antistatic packaging. Grasp the DCA by the handle with one hand and support the underside of the DCA with the other hand. [. . . ] Note: On all SuperLoaders, SCSI terminators must be used for proper operation of the drive. Handle For more information, visit our Web site at www. quantum. com United States of America Quantum Corporation Storage Solutions Group 141 Innovation Drive Irvine, CA 92612 U. S. A. phone 949. 856. 7800 fax 949. 856. 7799 Europe 7 Lindenwood Chineham Business Park Basingstoke, RG24 8QY United Kingdom phone +44 1256 818300 fax +44 1256 848700 Asia Pacific Level 3 200 Creek Street Brisbane, Qld 4000 Australia phone +61 7 3839 0950 fax +61 7 3839 0955 © 2004 Quantum Corporation. DLTtape, the DLTtape logo, Quantum, the Quantum logo, SuperDLTtape, the Super DLTtape logo, and SuperLoader are trademarks of Quantum Corporation registered in the U. S. A. [. . . ]