User manual QUANTUM 818126501A01

[. . . ] Though the components are similar in appearance, many components are not interchangeable. These include the magazines, cartridges, drive carrier assembly, magazine blank, magazine handle, and the bar code reader. Please order the appropriate part numbers when replacing these items. For additional information, visit www. quantum. com, refer to the Quantum Superloader Automated Tape Library User Manual installed as a PDF (portable document format) file on the enclosed CD, or contact Quantum Technical Support and Customer Service by calling 1-800-284-5101. [. . . ] The selected magazine is ejected from the SuperLoader. Caution: To prevent damage to the SuperLoader or the magazine/magazine blank, use both hands to support the magazine/magazine blank as you remove it from the SuperLoader. Grasp the magazine/magazine blank by the handle with one hand and slide it out carefully while supporting it from underneath with the other hand. SuperLoader Magazine Installation and Configuration Quick Start Guide Page 2 Magazine Step 3: Change the Magazine Orientation (If Necessary) Any magazine can be configured to fit in the right or left magazine bay. In default configuration, the magazine is oriented for the left bay. If the magazine is to be installed in the right bay, follow these steps: a. Position the magazine on the work surface so that the twocartridge openings are on top. Remove the two screws that secure the handle to the front of the magazine. Caution: Be careful not to break the hinge on the handle as you remove it from the magazine. Detach the handle by first sliding it in the direction of the screws removed previously and then pulling it off the magazine. Snap the handle on the front of the magazine and use the two screws removed previously to secure the handle in place. Step 4: Reinstall a Magazine Caution: To prevent damage to the SuperLoader or the magazine, use both hands to support the magazine as you install it in the SuperLoader. Also, ensure the magazine is properly positioned before slowly sliding the magazine into the bay. Grasp the magazine by the handle with one hand and support it underneath with the other hand. Slide Remove screws Pull off b. Slide the magazine into the magazine bay. Make sure you position the magazine correctly; it should slide in smoothly. The magazine is fully inserted when you feel it click into place and the front of the magazine is flush with the front panel of the SuperLoader. c. Rotate the handle 180 degrees so that what was the top of the handle is now the bottom. Handle oriented right Handle oriented left d. Rotate the magazine 180 degrees so that what was the front of the magazine is now the back. Make sure the twocartridge openings are still on top. Inserting the right magazine SuperLoader Magazine Installation and Configuration Quick Start Guide Page 3 Appendix A: Remove/Reinstall a Magazine Blank In default configuration, a magazine blank is installed in the right magazine bay when the SuperLoader is ordered with a 8tape cartridge capacity. This blank must be removed to upgrade the SuperLoader to a 16-tape cartridge capacity. This is explained in the preceding steps of this Quick Start Guide. [. . . ] Note: There is no need to rotate the blank. (5) Install the two screws to secure the handle to the magazine blank. SuperLoader Magazine Installation and Configuration Quick Start Guide Page 4 For more information, visit our Web site at www. quantum. com United States of America Quantum Corporation Storage Solutions Group 141 Innovation Drive Irvine, CA 92612 U. S. A. phone 949. 856. 7800 fax 949. 856. 7799 Europe 7 Lindenwood Chineham Business Park Basingstoke, RG24 8QY United Kingdom phone +44 1256 818300 fax +44 1256 848700 Asia Pacific Level 3 200 Creek Street Brisbane, Qld 4000 Australia phone +61 7 3839 0950 fax +61 7 3839 0955 © 2004 Quantum Corporation. DLTtape, the DLTtape logo, Quantum, the Quantum logo, SuperDLTtape, the Super DLTtape logo, and SuperLoader are trademarks of Quantum Corporation registered in the U. S. A. [. . . ]