User manual QUANTUM 818126601A01

[. . . ] It is recommended that authorized service personnel perform this upgrade. For additional information, visit www. quantum. com, refer to the Quantum Superloader Automated Tape Library User Manual installed as a PDF (portable document format) file on the SuperLoader Documentation CD, or contact Quantum Technical Support and Customer Service by calling 1-800-284-5101. Note: Adobe® Acrobat® Reader 4. 0 or later is required to view and print PDF documents. [. . . ] Set the bar code reader down on the work surface. Step 2: Unmount the SuperLoader Warning: Two persons are required to lift the SuperLoader or unmount it from a rack. Before you can install the bar code reader, you must remove the right magazine or magazine blank from the SuperLoader and then remove the SuperLoader from its rack or cabinet. For instructions about removing magazines and unmounting the SuperLoader from a rack, refer to the Quantum SuperLoader User's Guide. Note: Unmounting the SuperLoader requires a #1 PHILLIPS® screwdriver. This screwdriver will also be required during the remainder of the bar code reader upgrade procedure. SuperLoader Bar Code Reader Upgrade Quick Start Guide Page 2 Step 3: Prepare the Bar Code Reader Bay a. With the SuperLoader on a flat work surface, remove the top cover of the SuperLoader as follows: (1) Remove the PHILLIPS screws (SuperLoader LTO has four screws, SuperLoader DLTTM has two screws) from the top of the SuperLoader and four PHILLIPS screws from the back. SuperLoader (with top cover removed) Screws (back) e. Locate the small flex cable inside the bar code reader bay. Gently pull up on this cable to straighten it. Flex cable Step 4: Install the Bar Code Reader Screws (top) (2) Slide the cover backwards approximately 2 inches (5. 0 cm), and then lift it off. Locate the bar code reader bay directly above the picker. Pull the foam insert straight up to remove it. Then, discard the foam insert. Caution: These instructions are for both the SuperLoader DLT and the SuperLoader LTO due to the nature of their similarities. The bar code reader is not interchangeable. Please order the appropriate part numbers when replacing this item. Take appropriate ESD precautions including creating an antistatic work area and wearing an antistatic wrist strap and other antistatic apparel (smock, etc. ). Mirror Foam insert (being removed) Bar code reader b. Remove the bar code reader from its antistatic packaging. Avoid touching the bar code reader mirror. [. . . ] The bar code reader must be flush, or slightly below the level of the DCA fan shroud to avoid damage to the bar code reader. SuperLoader Bar Code Reader Upgrade Quick Start Guide Page 4 For more information, visit our Web site at www. quantum. com United States of America Quantum Corporation Storage Solutions Group 141 Innovation Drive Irvine, CA 92612 U. S. A. phone 949. 856. 7800 fax 949. 856. 7799 Europe 7 Lindenwood Chineham Business Park Basingstoke, RG24 8QY United Kingdom phone +44 1256 818300 fax +44 1256 848700 Asia Pacific Level 3 200 Creek Street Brisbane, Qld 4000 Australia phone +61 7 3839 0950 fax +61 7 3839 0955 © 2004 Quantum Corporation. DLTtape, the DLTtape logo, Quantum, the Quantum logo, SuperDLTtape, the Super DLTtape logo, and SuperLoader are trademarks of Quantum Corporation registered in the U. S. A. [. . . ]