User manual QUANTUM CP 3100 D2D2T 05-2004

[. . . ] CERTANCE Online User's Guide CP 3100 D2D2T Solution i Copyright and Trademarks Copyright © 2004 by Certance LLC. Part Number 50001836 May, 2004 Certance and the Certance logo are trademarks of Certance LLC. Other product names are trademarks or registered trademarks of their respective owners. Certance reserves the right to change, without notice, product offerings or specifications. [. . . ] If this is the first time you are logging in, enter the default IP address 192. 168. 0. 250. Otherwise, enter the IP address previously configured for the CP 3100. The Welcome page appears (see Figure 21 on page 45). NOTE: A subnet is a portion of a network that shares a common address component. On TCP/ IP networks, subnets are defined as all devices whose IP addresses have the same prefix. For example, all devices with IP addresses that start with 192. 168. 0. would be part of the same subnet. 44 Initial Setup Setting the Initial Configuration CAUTION: This procedure will fail if the computer is on a different subnet than the CP 3100 or if the CP 3100 has an IP address that is already in use by another device on the subnet. Figure 21. If this is the first time you are logging in, click the LOG IN button without entering a password. Otherwise, enter the appropriate password and click LOG IN. The Device Status page appears. NOTE: RemoteAdmin automatically logs you out after 20 minutes of idle time. If this occurs, log into RemoteAdmin, starting with step 1 on the previous page. 45 Initial Setup Setting the Initial Configuration Setting the CP 3100's Internal Clock The CP 3100 has an internal clock that tracks the current date and time. This clock is turned off when the CP 3100 is shipped. You must set the clock before you use the CP 3100. NOTE: Do not change the date or time when the CP 3100 is reading from or writing to virtual or physical tape cartridges. 1. Click CONFIGURATION. The Date/Time Settings page appears (see Figure 22 on page 46). Figure 22. Enter the information described in the Date/Time Settings page (see Table 3 on page 47). A message confirms that the date and time have been updated. NOTE: The Date/Time Settings page has a Reset button you can click to cancel your changes. If you enter the date and/or time using the wrong format, an error message appears showing the correct format to use. If this happens, click the Back button in your Browser and enter the appropriate date or time. 46 Initial Setup Table 3. Date/Time Settings Page Value Date Time Description Setting the Initial Configuration Enter the current date, in mm/dd/yyyy format. Example: 05/09/2004 is equivalent to May 9, 2004. Enter the current time, in 24-hour format using the syntax hh:mm:ss. Example: 14:18:56 is equivalent to 2:18:56 PM. Specifying a Password RemoteAdmin comes configured with no password. For security purposes, enter a password to guard against unauthorized access. [. . . ] Use the procedure under "Archiving to a Physical Tape for the First Time" on page 97 to erase your current physical tape using RemoteAdmin. With the Device Status page displayed, go to the Virtual Loader section and click the Configure icon ( 3. ) that corresponds to the slot number you want to archive. When the Configuration page opens, go to Advanced Operations and choose Use New Physical Cartridge (see Figure 50 on page 98). Figure 50. Insert the blank physical tape and the archive continues. The archive only writes the current data from the virtual cartridge to the physical tape. [. . . ]