User manual QUANTUM L200GUID

[. . . ] Quantum|ATL PowerStor L200 Series Library User's Guide 6322500-04 Ver. 0 Quantum|ATL PowerStor L200 Series Library User's Guide, 6322500-04, Ver. provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. may revise this publication from time to time without notice. [. . . ] Do not put labels on any other location. Caution: Never attempt to move the CHM manually. Damage to the library may occur if the CHM is blocking access to the fixed cartridge slot. Recycle power and wait until Library Idle is displayed on the OCP. The CHM will then be in its home position. Note: Use physical slot 1 (OCP slot 0) when performing a drive microcode update; use physical slot 8 (OCP slot 7) when using the optional AutoClean mode. Note: Insert and remove all cartridges from the front of the magazine. 40 Quantum|ATL PowerStor L200 Series Library User's Guide Chapter 4 Using the Library Using the Library Door Opening the Library Door To open the magazine door, using the OCP: 4 1 Press Select until the message EJECT/UNLOCK?Press Next to display the message Eject Cartridge?. Press Next to display the message Unlock Doors?. Press Enter to display the message Are you sure?. Press Enter to remove any cartridge from the drive and display the message Open Doors!. This activity can take up to three minutes if the cartridge is to be removed from the drive and the end of data is at the end of the tape spool. Press any other button to stop the operation. 2 3 4 5 6 Open the door using the handle. Note: When the door is unlocked, the message Door Unlocked!The only way to restore library operation is to open and close the library door. Closing the Library Door To close the library door, push the door until it latches. 4 The door automatically locks after approximately five seconds. The library automatically executes a scan magazine function. When the scan magazine function is complete, the message Eject/Unlock?If the optional bar code reader is present, the cartridge label bar codes are read. Quantum|ATL PowerStor L200 Series Library User's Guide 41 Chapter 4 Using the Library Using Tape Cartridges Using Tape Cartridges This section contains information on: · · · Loading and unloading data cartridges Using cleaning cartridges Bar code labels 4 Inserting a Cartridge To insert a tape cartridge into the magazine: 4 1 2 Open the library door. Verify that all library SCSI library activity has stopped (the message Library Idle will be displayed on the OCP). Set the write-protect switch on the tape cartridge to the desired position (see figure 12). Note: The cartridge is write-protected if the orange indicator is visible. [. . . ] F FCC Class A Standard established by the U. S. Federal Communications Commission governing electromagnetic emissions in a commercial environment. FRU Field-replaceable unit--A term given to parts of the library that are designed to be replaced onsite. H Host or host computer The computer that issues SCSI commands to control the library robotics and tape drives. HVD High-voltage differential--A standard method of driving SCSI cables that has been in use for years. I inventory An operation in which the library determines the identity and location of all tape cartridges and SCSI elements. [. . . ]