User manual QUANTUM LTO-1 INSTALLATION REV B

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual QUANTUM LTO-1. We hope that this QUANTUM LTO-1 user guide will be useful to you.

Lastmanuals help download the user guide QUANTUM LTO-1.

Download

You may also download the following manuals related to this product:

QUANTUM LTO-1 03-2004 (715 ko)

Manual abstract: user guide QUANTUM LTO-1INSTALLATION REV B

Detailed instructions for use are in the User's Guide.

 [. . . ] LTO Autoloader Rackmount Kit
Installation Guide

Part Number 10010533-001 April 2003 Rev. B January 2004 Copyright © 2004 Certance LLC.  [. . . ] This unit is intended to be connected to Earth ground. 

Rackmount Kit Hardware
The tablebelow lists all items shipped with the rackmount kit. Description Rail assembly (right and left side) L-brackets (right and left side) Phillips screws Cage Nuts Washers Quantity 2 2 10 10 10

Tools Required · · Small flat-blade screwdriver # 2 Phillips screwdriver

Converting from Desktop to Rackmount
When converting a desktop autoloader to a rackmounted unit,  you must install the rail assemblies onto the rack,  attach the L-brackets to the autoloader,  and then install the autoloader into the rack. 

2

LTO Autoloader Rackmount Kit

Installing the Rail Assemblies to the Rack
The rackmount kit contains two rail assemblies that you mount to the rack. Open the shipping carton,  remove the rail assemblies and associated hardware. Verify that you have all the components listed in the table above. Position two cage nuts on the front of the rack and two on the back of the rack. Position the left rail assembly on your rack,  matching the holes on the front and rear of the rails with the holes on your rack,  to which the cage nuts have been added. Using a # 2 Phillips screwdriver,  attach the rail assemblies to your rack with four of the Phillips screws (two screws on the front and two on the back of the rack) and four washers. Note that the front of the rack is shown in the following illustration. 

3

LTO Autoloader Rackmount Kit

Installing the L-Brackets on the Autoloader
The rackmount kit contains two front L-brackets. To install the L-brackets on the autoloader 1. Power down the autoloader,  then remove the SCSI cable(s) and power cord from the rear of the autoloader. Using a small flat-blade screwdriver,  remove the front screws that secure the right and left side of the autoloader cover (two screws on each side). Match the holes on the L-brackets to the holes on the autoloader cover.  [. . . ] Reconnect the SCSI cable(s) and power cord to your autoloader (see the User's Guide). Your autoloader is now ready for use as a rackmounted unit. 

6 [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE QUANTUM LTO-1

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual QUANTUM LTO-1 will begin.