User manual QUANTUM QUANTUM KEY MANAGER INSTALLATION REV A

[. . . ] To help prevent damage to server components, always install a filler panel to cover the open space and to help ensure proper air circulation. Do not extend more than one device out of the rack cabinet at the same time. Connect all power cords to properly wired and grounded electrical outlets. Do not overload the power outlet when installing multiple devices in the rack. [. . . ] Then, press tab 2 to secure the rear of the slide rail to the rear mounting flange. slide rail. Important: Ensure that the pins are fully extended through the mounting flange and Figure 3 Securing the Slide Rail to the Rear Mounting Flange Tab 2 Release tab Pins extended through the mounting flange and slide rail Pins not extended through the mounting flange and slide rail 3 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 3 Align the pins on the front rail-locking carrier to the front mounting flange. If you adjusted the rail length, push the rail-locking carrier back toward the rear of the slide rail to align the slide rail with the mounting flange. Then, press tab 2 to secure the front of the slide rail to the front mounting flange. See Figure 4. Important: Ensure that the pins are fully extended through the mounting flange and the slide rail. Repeat step 1 and step 2 for the other slide rail. Figure 4 Securing the Slide Rail to the Front Mounting Flange Mounting flange Tab 2 Pins extended through the mounting flange and slide rail Pins Pins not extended through the mounting flange and slide rail 4 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 4 Transporting the rack cabinet with the server installed. If you do not plan to transport the rack cabinet to another location with the server installed, skip this step. If you plan to transport the rack cabinet to another location with the server installed, remove the large screw and discard it. Remove and save the front screw and loosen the two rail screws. Then, fully extend the rail and insert the screw you saved into the position where the large screw had been located. Repeat this step for the other rail. Figure 5 Securing the Rail for Transport Rail screws Front screw Large screw 5 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 5 Align the server on the slide rails and push the server fully into the rack cabinet. Secure the server to the front mounting flanges with the captive thumbscrews. Note: You must leave the shipping brackets attached to the slide rails unless the shipping brackets impede the server from sliding fully in the rack cabinet. If you need to remove the shipping brackets, continue with the next step. Figure 6 Securing the Server to the Front Mounting Flanges Shipping brackets Server Captive thumbscrews 6 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 6 Removing the shipping brackets. Only remove the shipping brackets if they impede the server from sliding fully in the rack cabinet. Press on the release tab as indicated on the shipping bracket, and remove the shipping bracket from the slide rail. [. . . ] Go to steps 4, 5, and 6 for instructions. Figure 9 Securing the Server to the Rack for Transport Made in the USA. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice. COPYRIGHT STATEMENT © Copyright 2009 by Quantum Corporation. [. . . ]