User manual QUANTUM SCALAR 100

[. . . ] Scalar® 100 User's Guide ADVANCED DIGITAL INFORMATION CORPORATION www. adic. com Copyright © 2002-2006 ADIC The information contained in this document is subject to change without notice. This document contains proprietary information which is protected by copyright. No part of this document may be reproduced, modified, distributed, or translated to another language without prior written consent of ADIC. ADIC USA 11431 Willows Road NE Redmond, Washington 98052-4952 Tel. : 1-800-336-1233 Fax: 1-425-881-2296 This document may describe designs for which patents are pending, or have been granted. [. . . ] To do this procedure, the front door must be unlocked or you must have the key. In addition, before starting, ensure the tape cartridges have barcode labels and are not write-protected. If your library is partitioned (through the host software), be aware of where you are placing tape cartridges. CAUTION 1 2 3 Place the library in an Offline state. Refer to Using Commands that Require an Offline State on page 46. If the library door is locked, unlock the door. Open the door, and put the tape cartridges into the slots. (Lock it if necessary. ) The library executes the TEACH and INVENTORY procedures. Exporting a Tape Cartridge Use Export to remove tape cartridges from your library through the mailbox. Export takes a specific tape cartridge and places it in the mailbox so that you can remove it from your library. To use this procedure, the mailbox cannot be configured as storage. Scalar 100 User's Guide 63 Path: Main Menu > Command > Mailbox > Export 1 2 3 4 From the main menu, select Command and then select Mailbox. The panel shows a list of tape cartridges in the library. Press Select to begin choosing the tape cartridge(s) you want to export. Use Next, Select, and Pages to choose the tape cartridge(s) you want to export. Highlighted cartridges will be exported. You can only export as many tape cartridges as your mailbox holds. 5 When complete, press OK. Manually Removing Tape Cartridges If you need to remove a large number of tape cartridges, you probably will want to manually remove them. If you only have a small number of tape cartridges to remove, use the Export command as it does not interfere with library operations. To do this procedure, the front door must be unlocked or you must have the key. 1 2 3 Place the library in an Offline state. Refer to Using Commands that Require an Offline State on page 46. If the library door is locked, unlock the door. Open the door, and remove the tape cartridges. (Lock it if necessary. ) The library executes the TEACH and INVENTORY procedures. Working with Cleaning Cartridges The AutoClean menu allows you to import and export cleaning cartridges. [. . . ] 69 barcode labels See barcode scanner barcode scanner about . 112 Scalar 100 User's Guide 117 installing . 67 errors See also logs See also troubleshooting diagnostic files . 105, 109 Operator Information messages . [. . . ]