User manual QUANTUM SCALAR DISTRIBUTED LIBRARY CONTROLLER 2.4 INSTALLATION

[. . . ] Scalar DLC Scalar Distributed Library Controller Installation Guide Document Number: 6-00659-01 Version 2. 4 Copyright Notice © 2003 ADIC The information contained in this document is subject to change without notice. This document contains proprietary information which is protected by copyright. No part of this document may be photocopied, reproduced, or translated to another language without prior written consent of ADIC. ADIC shall not be liable for errors contained herein or for incidental or consequential damages (including lost profits) in connection with the furnishing, performance or use of this material whether based on warranty, contract, or other legal theory. [. . . ] After Node2 booted up, stop cluster service on Node1 using Control Panel > Administrative Tools > Cluster Administrator applet. See Installing the Scalar DLC Software on page 42. a. Launch Scalar DLC Typical installation at Node2. Install MSDE 2000 in the same folder on external (RAID) disk (e. g. Specify "Use existing database" during the installation of Scalar DLC software. When the installation of Scalar DLC is finished, restart Node2. Step 3 Configure the Scalar DLC software for the Cluster mode. Make sure that cluster services are running on both cluster nodes. Using any node, launch the cluster utility for automatically configuration of all necessary common resources. It can be found at Scalar DLC Installation CD by the following path: Scalar_DLC\Cluster\SDLC_ClusterConfig. exe (see the figure below). Figure 43 Start SDLC Cluster Configuration Installation Guide 37 Scalar DLC c. Figure 44 SDLC Cluster Configuration: no configuration d. When the configuration completes, the pop-up window opens. Click OK to return to the SDLC Cluster Configurator (see the figure below). 38 6-00659-01 Scalar DLC Figure 46 SDLC Cluster Configurator: configuration complete f. Close the Scalar DLC Cluster configurator tool (X-button). Open Start > Settings > Control Panel > Administrative Tools > Cluster Administration (see the following figure) and make sure that the SDLC Supervisor service is a part of a Cluster group. Figure 47 Cluster Administration Configure the Logical Library Step 1 Using any node, log in as administrator or as a domain user with the local administration rights and start the Scalar DLC software if it is not started automatically. 39 Installation Guide Scalar DLC Step 2 Double click the Scalar DLC Manager icon to start the Scalar DLC Management GUI from a local computer. From a remote computer, use http://ScalarDLC-machine-name in current browser. NOTE: It is strongly recommended to use the virtual Cluster name here (e. g. Step 3 The first start of the Scalar DLC Management GUI launches the configuration engine. Select either the Automatic or Manual configuration option to configure the logical library automatically, or Advanced configuration option in case of more then one logical library should be created. Refer to the Configuration chapter of the Scalar DLC Reference Manual for instructions. NOTE: The operating system and its service packs on both cluster nodes must be identical and they must remain identical. Otherwise it may cause cluster service malfunctions. [. . . ] If the Scalar DLC database has been installed under user account, either the SQL administrator logon name/password, or the Scalar DLC SQL user name/password are required. Backup the database to file (for example, "OldSDLC. db"). See Figure 104. Installation Guide 85 Scalar DLC Figure 104 Backup Database Step 2 Step 3 Remove the old release of Scalar DLC with the database. Install MSDE 2000 and Service Pack 3 for MSDE2000. [. . . ]