User manual QUANTUM SCALAR I80 QUICK START GUIDE 2

[. . . ] Scalar i40 and Scalar i80 Contents Required Tools and Equipment . . . . . . . . . . . . . . 2 Environmental Requirements . . . . . . . . . . . . . . . . 2 Taking ESD Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Unpacking the Library. . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Once you accept a setting, you move to the next one. Remember that you can always change the configuration later if needed. · To cancel out of the Setup Wizard and begin using the library immediately, press the button corresponding to Cancel on the menu bar. This accepts the library's default configuration, including an IPv4 address assigned by DHCP. The Setup Wizard will not appear on the operator panel again, but you can change any of the configuration settings later using the Setup menus on the operator panel or the Web client. It is easier to configure the library using the Web client, so you may wish to cancel now. To access the Web client immediately, skip the rest of this section and go to Accessing the Library Via the Web Client on page 13. Turning the Library ON and Configuring Network Settings 9 Scalar i40 and Scalar i80 Quick Start Guide 5 The Setup Date/Time screen appears (see Figure 5). Figure 8 Setup Wizard ­ Date/Time Screen Do one of the following: · To accept the date and time, press the Accept button. · To change the date or time, press the Change button. The Date field becomes available to edit and the menu bar button designations change. Use the Left and Right buttons to move through the date field, one segment at a time. Use the Up and Down buttons to change each segment of the date value. If they are not installed, you will have received, separately, a License Key Certificate containing instructions on how to retrieve your license key from the Quantum Web site. Once you have retrieved your license key, you may add it now or any time later. (If you did not receive your License Key Certificate, contact Quantum Support. ) Figure 11 Setup Wizard ­ Licenses Screen Turning the Library ON and Configuring Network Settings 11 Scalar i40 and Scalar i80 Quick Start Guide Do one of the following: · To accept the settings and go to the next step, press Accept. · To change the settings, press Change. You can only change the settings if you have a new license key to enter. If you have a license key, press Add, then enter the license key using the directional buttons as described in Step 5 on page 10 and press Accept when complete. If you need to add another license key, perform the Change operation again. 8 The Current Configuration screen appears, displaying the default number of partitions, I/E station slots, and cleaning slots (see Figure 12). Figure 12 Setup Wizard ­ Current Configuration Screen Do one of the following: · To accept the current settings, press Accept. · To change any of the settings, press Change. This will delete the current partitions, and you are asked to confirm you want to do this. If you agree, the library deletes the partitions, which takes about 30 seconds. [. . . ] The robot will move to the I/E station and scan the newly installed tape cartridges. When finished, the operator panel asks you to assign the cartridges to a partition. Use the Up and Down buttons to select a partition, then press the Apply button. Note: You must assign all the newly installed tape cartridges to the same partition. [. . . ]