User manual QUANTUM SUPERLOADER 3

[. . . ] User's Guide User's Guide User's Guide User's Guide User's Guide User's Guide User's Guide SuperLoaderTM 3 SuperLoader 3 81-81317-07 B01 Quantum SuperLoader 3 User's Guide, 81-81317-07 B01, June 2010. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice. COPYRIGHT STATEMENT Copyright 2010 by Quantum Corporation. [. . . ] When you have advanced through all of the digits of the gateway address, the autoloader displays Enter to save. Note: If you make a mistake, press Escape to backspace to the digit you want to change. New Gateway is xxx. xxx. xxx appears on the LCD. You do not need to reboot the autoloader. 6 Press Escape or Enter to return to the Ethernet submenu. System Time The system time is displayed by On-board Remote Management and it is used internally when logging events and errors. The system time is either regular time or power-on time. Regular time is Month/Date/Year Time, such as Nov/21/2004 19:28. Power-on time is Power On Cycles/ Power On Hours. For example, POC: 00121, POH: 00002:07:45 where POC is the number of times the system has booted since it was manufactured, and POH is the number of hours, minutes, and seconds since the last system boot. If regular time is known, it will be used, otherwise power-on time is used. Setting the Time Zone To set the time zone: 1 From the main menu, scroll to Configuration, and then press Enter. 2 From the Configuration menu, scroll to Time, and then press Enter. 3 From the Time submenu, scroll to Set Timezone, and then press Enter. The Time Zone screen appears, allowing you to set the hours. The cursor automatically appears at the first digit. 4 Scroll to set the number of hours difference between your local time and Greenwich Mean Time (GMT). 5 Scroll to set the number of minutes difference between your local time and GMT, then press Enter. The new time zone is set. Quantum SuperLoader 3 User's Guide 69 Chapter 5 Administration Setting the Change Mode 6 Press Escape or Enter as necessary to return to the main menu. Setting the Date and Time To set the date and time: 1 From the main menu, scroll to Configuration, and then press Enter. 2 From the Configuration menu, scroll to Time, and then press Enter. 3 From the Time submenu, scroll to Set Date/Time, and then press Enter. The Date/Time screen appears, allowing you to set the date and time. The cursor automatically appears at the first digit. 4 The first four digits represent the current year. [. . . ] surface The side of the tape that is coated with the magnetic material for recording data. sustained transfer rate The data transfer rate of a tape drive in native mode. for example, the DLT 7000 has a sustained transfer rate of 5 MB in native mode, and up to 10 MB at 2:1 compression. system manufacturers Makers of computer systems and tape library systems. [. . . ]