User manual RADEX COMPTEUR GEIGER

[. . . ] Installation and all gas/electric connections must be carried out by a qualified technician in accordance with the manufacturer's instructions and in full compliance with current laws and safety regulations. This appliance is intended solely for domestic use and is designed for the following functions: cooking and reheating food. Any other use is considered as improper. The manufacturer declines all liability resulting from poor installation, tampering, inexpert use and use for purposes other than those specifically stated. [. . . ] By moving the indicator to coincide with the printed symbols, the following adjustment can be made: Tap closed, no gas delivery Maximum capacity, maximum gas delivery Minimum capacity, minimum gas delivery Burners ignition These models are equipped with safety valves which automatically shut off the gas delivery in the event the burner should, for any reason, go out. To relight the burner, turn the knob to position "tap closed" and repeat the ignition procedure explained in the following paragraphs. For ignite a burner, turn the gas tap knob to the maximum delivery position, then press and hold down it for about 4÷ 5 seconds. Warnings: - Once the burner is light on, adjust the flame by turning the knob to obtain the desired intensity. The setting must always be positioned between the maximum and minimum, and never between the maximum setting and the off position. - If the burner is difficult to light on, or if the flame is tall or irregolar, turn off immediately turning the knob to "off" position and call Assistance Service. - If the particular nature of the local gas supply makes it difficult to ignite the burners with the knob turned to the maximum setting, repeat the operation without a pan in position and with the knob turned to the minimum setting and without pan stands. - Warning: The ignition device must not be used for more than 15 seconds. If after this length of time the burner does not light, or if it goes out again accidentally, wait 1 minute before trying to ignite it again . Grids The panstand grids are designed to make the appliance easy and safe to use. Always check the panstand grids are properly positioned before using the appliance. Correct installation of the sealing gasket ensures complete protection against infiltration of liquids. Installation area and removal of combustion fumes The appliance must be installed and operated in suitable areas, and in compliance with current laws. The installation technician must observe current laws governing ventilation and removal of combustion fumes Please remind that the air required for combustion is 2m3/h per kW of power (gas) installed. Installation area In the room where the gas appliance is installed, there must be a sufficient natural air supply to allow the gas to burn correctly (in conformity of currents laws). The natural flow of air must take place through an opening made on an outside wall of the room and having a working section of at least 100 cm2 (A). In the case of appliances without safety valves, this opening must have a minimum working section of 200 cm2 (fig. This opening must be made in such a way that it cannot be obstructed from inside or outside. It should be positioned near floor level, preferably on the side opposite the fume exhaust devices. If it is not possible to make the necessary openings, the air can be supplied from an adjacent, suitably ventilated room, as long as this room is not a bedroom, a dangerous area or a lowpressure area. Removal of combustion fumes Combustion fumes produced by gas appliances must be removed by means of a hood connected directly either to an exhaust duct or to the outside (fig. If a hood cannot be installed, an electric extractor fan must be fitted to the outside wall or the window. [. . . ] If the power cable must be replaced, use a cable having identical characteristics to the original supplied by the manufacturer, suitable for the load and temperature (type T90°C). This is available from After-sales service. Furthermore, the end of the power cable to be connected to the appliance must have the Yellow-Green earth conductor 20 mm longer than the other conductors. The cable must support the load of the appliance. [. . . ]