User manual RADIOSHACK 4-IN-1 FAMILY FAVORITES REMOTE

[. . . ] NOTE: You may not include the user or genre keys in the Power macro. You can set the remote to control a second TV, DVD player, or other device (see Manufacturer's Codes). For example, if you have two DVD players, but no VCR, and you wish to control both DVD players with the remote, you can reassign the unused VCR key to the DVD player: 1. Press and hold P until the red LED blinks twice, then release. [. . . ] Also, keep this guide for future reference. Enter channels over 100 (for example, +100, 3, 1 = 131). For a DVD player, use +100 to access chapters over 10 (for example, +100, 3 = 13). Input channel number entries on some TV models or make a selection on a device's menu. Control your VCR, PVR, DVD player, or Video On Demand (VOD) if available on your cable/satellite service. Press and hold P until the red LED blinks twice, then release. Enter 9 9 3 and then press the mode key for the device you want to control volume (for example, TV). Now when you press VOL+, VOL-, or Mute, the selected device (for example, TV) will control the volume regardless of the current mode. After performing Global Volume Lock (above), press and hold P until the red LED blinks twice, then release. Press the mode key for the device you want to have independent volume control. Repeat steps 1 to 3 for any other device that you want to have independent volume control. The RadioShack 4-1 Family Favorites Remote comes pre-programmed to operate an RCA TV, VCR, DVD player, and Satellite receiver. To control devices other than those default brands, follow these steps; otherwise, skip this section. Before proceeding, find the codes for the devices you want to program in Manufacturer's Codes and write them down or highlight them. If you have a VCR/DVD combo, you may need to set up both a VCR and DVD code. Turn on the device (for example, DVD player) and, if needed, load media (for example, a DVD). Press and hold P until the red LED blinks twice, then release. Enter the first four-digit code for your device. The LED blinks once as you enter each digit. if the code is correct , the LED blinks twice. NOTE: If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again. If it does not, repeat steps 2 to 5, trying each code for your brand until you find one that works. [. . . ] If it gets wet, wipe it dry immediately. â· Use and store the remote only in normal temperature environments. Wipe the remote with a damp cloth to keep it looking like new. Modifying or tampering with the internal parts can cause damage and invalidate the warranty. [. . . ]