User manual RADIOSHACK 4-IN-1 REMOTE CONTROL

[. . . ] 15-1991. fm Page 1 Wednesday, October 20, 1999 10:37 AM Cat. 15-1991 OWNER'S MANUAL 4-in-One Remote Control Please read before using this equipment. 15-1991. fm Page 2 Wednesday, October 20, 1999 10:37 AM FEATURES Your RadioShack 4-in-One Remote control can replace up to four infrared remote controls. You can use it to control your TV, VCR, TV/ VCR combination, cable converter, CD player and more. Unlike some universal remote controls, the 4in-One Remote is preprogrammed with the most commonly used commands, so it does not have to learn its commands from the original remote controls. [. . . ] Hold down P until the red light blinks twice, then enter the 4-digit manufacturer's code. When the red light blinks twice again, the remote control has accepted the code. Note: If the code you entered is invalid, the red light blinks. Point the remote control at your TV/VCR combination and press POWER. Your device should turn off (or on, if it was off). If the remote does not operate your device, try the other codes listed for your TV/VCR combination. Note: Some TV/VCR combinations require a second code to control volume. If you cannot get the volume to work, use the TV code listed in "TV/VCR Combinations" on Page 33. 7 15-1991. fm Page 8 Wednesday, October 20, 1999 10:37 AM OPERATION 1. Press the device key for the device you want to control. Point the remote control toward the device you want to control, then press the desired command keys. Repeat Steps 1 and 2 for all other devices you want to operate. Note: The command keys on the remote control work the same as the keys on the original remote control; however, the labeling might differ slightly. To turn off the last device you selected, press POWER. To turn off other devices, press the device key for the device you want to turn off, then press POWER. CONVERTING DEVICE KEYS You can use the 4-in-One Remote to operate a second TV or VCR (or other components) for a total of up to four devices. To do this, you must first convert an unused device key (TV, VCR, CBL, AUX) to operate each additional device. For example, to convert AUX to operate a second TV: 1. Hold down P until the red light blinks twice. Program the converted device key (AUX) with the code for the second TV. (See "Setting Up Your Remote Control" on Page 6. ) Repeat these steps for each key you want to convert. To convert a key back to its original 8 15-1991. fm Page 9 Wednesday, October 20, 1999 10:37 AM function, repeat Steps 1­2, then press AUX twice. PUNCH-THROUGH The punch-through feature lets you alternately control two different devices without pressing the device keys for each one. A TV is often the only device that uses the volume keys. Punch-through allows you to control the TV's volume while the 4-in-One is in any device mode. [. . . ] If it gets wet, wipe it dry immediately. · Use and store the remote control only in normal temperature environments. · Handle the remote control gently and carefully. · Keep the remote control away from dust and dirt. [. . . ]