User manual RANE CP R2 INSTALLATION

[. . . ] The front panel PAGING ZONE ASSIGN switch (see Front Panel, balloon #6) routes one paging source and the configuration adapter routes the other. Setting the CONFIGURATION ADAPTER: To page only in ZONE 1 twist the black and green wires together. To page only in ZONE 2 twist the black and red wires together. [. . . ] ZONE 1 MONO MODE This delivers a total of three mono zones from the CP 62. Zone 1a and 1b use the same source with independent LEVEL controls. To separate Zone 1 into 1a and 1b, use two R2 remotes connected to Zone 1. Plug a cable from the MAIN jack of the first R2 into the ZONE 1 REMOTE jack on the back of the CP 62 and set the first R2s slide switch to DUAL MONO, as shown in Figure 1b. Plug a cable from the MAIN jack of the second R2 into the AUX jack on the first R2. A third R2 plugged into the CP 62 ZONE 2 REMOTE jack gives control over the third mono zone, operated as Zone 2. Figure 1a. Figure 1b. Table 1. R2 Installation Options Desired Configuration 1 Stereo Zone (Zone 1) 1 Mono Zone (Zone 2) Both of the above 3 Mono Zones (Zones 1a, 1b, & 2) Zone 1a and 1b use the same Source Selection Remote Functions SELECT & stereo LEVEL SELECT & mono LEVEL both as above Independent mono LEVEL for Zone 1a, 1b, and 2. Zone 1 Mode STEREO not applicable STEREO MONO R2 Connections CP 62 ZONE 1 SOURCE & LEVEL jack CP 62 ZONE 2 SOURCE & LEVEL jack 2 R2 units both as above Use 3 R2s. Zone 1a - first R2's MAIN to the CP 62 ZONE 1 SOURCE & LEVEL jack. Zone 1b - second R2's MAIN to the first R2's AUX jack. Zone 2 - third R2 to CP 62 ZONE 2 SOURCE & LEVEL jack. DECORA is a registered trademark of Leviton Manufacturing Co. , Inc. Preparing the cables All modular connectors are not created equal. The typical modular plug that connects to your telephone is a 6-position/ 4-conductor connector, named by an RJ number to describe it (i. e. This type of connector will not fit into the CP 62 remote outlets. The appropriate connector for the CP 62 is a 4-position/4-conductor, and is referred to as a "telephone modular handset connector". It does not have an RJ number to describe it. Most companies have their own different part numbers for this part. Install standard copper stranded 28-26 guage 4 conductor flat telephone cable to an empty electrical box where the remote is to be located. Do not use high flexibility tinsel cable. [. . . ] DECORA wall plates are available in a wide range of colors at most hardware stores. Figure 4. Three Mono Zones Control Example Figure 3b. Stereo and Mono Zone Control Example ©Rane Corporation 10802 47th Ave. [. . . ]