User manual RANE EMPATH

[. . . ] · Left/Right, constant-level PAN controls: ° The loudness stays the same in the room as you Pan left to right. · 3-band, full-cut tone controls: ° +6 dB boost to full-cut (off). nd ° 2 -order Linkwitz-Riley filter topology. · EQ engage switch ° Allows "transform" EQ effects. [. . . ] · SPLIT CUE switch "OUT": CUE / MASTER control pans between stereo Cue selection and stereo Master mix. · SPLIT CUE switch "IN": CUE / MASTER control pans between: mono-Cue in the left channel and mono-Master in the right channel. · Headphone LEVEL control determines the loudness. · Two-band Headphone EQ: Maximum boost: 12 dB Maximum cut: -12 dB Center frequency: 1 kHz. ·1 /8" (3. 5 mm) and ¼" jacks provided. LOW HIGH Manual-3 Mic Input · Balanced ¼" TRS input (Tip (+), Ring (­), Sleeve (ground) · Accepts unbalanced ¼" TS (Tip-Sleeve) plugs. · Mic Engage switch turns the Mic on and off without changing the Mic level. ° Green indicator lights when engaged. · MIC level control range is Off to +50 dB · Overload Indicator: ° Lights 3 dB before clipping. ° Monitors the signal level before and after the HI and LOW tone controls. ° If it lights, turn the MIC level down and/or reduce the tone control boost. · 2-band tone control: ° Maximum boost: 12 dB. · FlexFX effects loop: ° WET (effect), DRY (no effect) pan control. ° Process mic with any combination of input channels. ° See FlexFX Effects Loop section for details. INPUT 1-2-3 AUTO-GAIN MIC ENGAGE 4 2 0 6 8 10 MIC OL -12 +12 HI -12 +12 LOW AUX Input and Output · AUX Input: ° Unbalanced RCA jack. ° AUX CUE signal is sent to the cue circuit before the AUX IN level control. ° AUX IN level control range is Off to +10 dB. ° AUX input sums to the Master mix after the Crossfader and FlexFX loop. · AUX Output: ° Unbalanced RCA jack. ° AUX OUT control range is Off to +0 dB ° Source is the Master mix: Program 1, 2, 3 (pre- or post-effects) plus the Mic (pre- or post-effects) plus the AUX Input. DRY MIC WET 4 2 0 6 8 10 AUX IN CUE AUX Booth Output · Balanced ¼" TRS output · Level control range is Off to +6 dB · Source is the Master mix: Program 1, 2, 3 (pre- or post-effects) plus the Mic (pre- or post-effects) plus the AUX Input. 4 2 0 10 6 8 MAIN 4 2 0 10 6 8 BOOTH Main Output · Balanced XLR output. · Level control range is Off to +6 dB. · Source is the Master mix: Program 1, 2, 3 (pre- or post-effects) plus the Mic (pre- or post-effects) plus the AUX Input. 2 4 6 8 0 10 AUX OUT Manual-4 Level Meters · Level Meters have two modes of operation: ° Stereo Main output ° Cue Monitor. · Meter mode switch set to MAIN "out": ° Meter displays the level at the Main output, after the Main output LEVEL control. [. . . ] c) Lubricate the guide rod by placing one small drop of silicon oil, using a cocktail stick, either side of the slider assembly. Move the slider from end to end in order to disperse the oil evenly. Carefully wipe away any excess oil using a tissue or cloth. e) Insert the dust cover and damping washer. [. . . ]