User manual RANE MLM 103

[. . . ] The AUX ASSIGN button is always a mono mix of the stereo channel. MLM 103 CONNECTION INPUTS The MLM 103 has ten balanced Euroblock Inputs. For best noise rejection use two-conductor-plus-shielded wire, even for unbalanced operation. Connect the non-inverting (positive) audio lines to the "+" terminals, and the inverting (negative) lines to the "­" terminals. Connect the shields to the "ground" terminals. [. . . ] Mic/Line OVERLOAD LED monitors the signal level before and after the Equalizer. When the A/B assign button is engaged and the MONO button is not engaged, Input 7 (or 9) is routed to the A Output, while Input 8 (or 10) is routed to the B Output. When both the A/B ASSIGN and MONO buttons are engaged, both Inputs of 7 and 8 (or 9 and 10) will be routed to both the A and B Output. The AUX ASSIGN button is a mono mix of the stereo Inputs. Stereo Line INPUT LEVEL controls 7/8 and 9/10 determine the amount of stereo or mono line signal to be delivered to the assigned Outputs. Stereo Line OVERLOAD LED monitors the signal levels after the Equalizer and after the line gain stage. Output Meters indicate the overall levels of Outputs A, B and the AUX Output. A, B and AUX OUTPUT LEVEL controls set the Output Level for A, B and AUX Outputs. POWER LED lights whenever adequate power is applied to the unit. Manual-2 REAR PANEL DESCRIPTION MIC/LINE INPUT TRIM controls 1-6 adjust the input gain of the Mic/Line Inputs. The gain range for Mic level is 12 to 60 dB. The gain range for Line level is -4 to 12 dB. LINE/mic INPUT buttons 1-6 switch the sensitivity and input impedance for either a microphone or line input. Mic level is selected when the button is in the "out" position. Line level is selected when the button is in the "in" position. MIC/LINE INPUT connectors 1-6 are balanced Euroblocks that connect either microphone or line signals. PHANTOM POWER button applies 12 volt phantom power to each pair of Mic/Line Inputs. STEREO LINE INPUT connectors 7/8 and 9/10 are pairs of balanced Euroblock connectors, to accommodate stereo or mono line level signals. PRE/post MIX LEVEL DIRECT OUTPUT buttons. When this switch is in the "in" position, the Direct Output signal is not affected by the Input's Level control. When this switch is in the "out" position, the Direct Output signal is affected by the Input's Level control. DIRECT OUTPUTS are balanced Euroblocks that directly connect each Mic/Line Input signal to other audio devices as needed. These Direct Outputs are post-Equalizer. [. . . ] STEREO LINE LEVEL INPUTS 7/8 and 9/10 When a stereo source (CD, DVD, cassette, etc. ) is connected to Inputs 7/8 (or 9/10), the routing is as follows: When the A/B ASSIGN button is engaged and the MONO button is not engaged, INPUT 7 (or 9) is routed to the A Output, while INPUT 8 (or 10) is routed to the B Output. When both the A/B ASSIGN and MONO buttons are engaged, a mono mix of INPUTs 7/8 (or 9/10) will be routed to both the A and B Outputs. The AUX ASSIGN button is always a mono mix of the stereo channel. OUTPUT LEVELS After all of the Mic/Line and Stereo Input Levels have been adjusted and routed, adjust the OUTPUT faders so the Meters peak average around 0 to +2. [. . . ]