User manual RANE MLM 82S

[. . . ] Now slowly raise the OUTPUT LEVELS as desired. MLM 82S CONNECTION When connecting the MLM 82S to other components in your system for the first time, leave the power cord for last. This gives you a chance to make mistakes and correct them without damage to your fragile speakers, ears and nerves. MIC/LINE INPUTS 1-4 The four XLR jacks provided on the MLM 82S are balanced MIC/LINE inputs. They will also accept unbalanced connectors. [. . . ] 6 OUTPUT OverLoad LED illuminates within 3 dB of an approaching overload condition. To avoid this, the associated OUTPUT LEVEL control may be decreased, or the problem-causing individual Input Level may be lowered. 7 A and B OUTPUT LEVEL controls set the Output Level for A and B outputs. 8 POWER LED is lit whenever adequate power is applied to the unit. Manual- REAR PANEL DESCRIPTION 5 MLM 82S MADE IN U. S. A. BALANCED: PIN 3 = (­), PIN 2 = (+), PIN 1 = (G) COMMERCIAL AUDIO 4 A A A A A 1 6 B 100-240 V EQUIPMENT 24TJ 50/60 Hz 7 WATTS R B THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES FOR A CLASS 'B' COMPUTING DEVICE. 8 B 7 B 5 B 4 LINE 3 LINE 2 LINE 1 LINE PHANTOM POWER ACN 001 345 482 OUTPUTS LINE INPUTS MIC / LINE INPUTS 6 3 2 1 MIC/LINE INPUTS 1 through 4. These XLRs connect either balanced Microphone or Line signals, depending on the LINE switch setting (see 3). Rane adheres to the international and U. S. standard for balanced pin configurations: Pin 1 is chassis ground (neutral), pin 2 is positive (+), and pin 3 is negative (­). 2 PHANTOM POWER switch applies 15 V Phantom Power to any Inputs 1-4 that are set for MIC Input. 3 LINE Input selectors switch the sensitivity and input impedance for either a microphone or line level input. If LINE is chosen, Phantom Power is deactivated for that Input. These stereo pairs of balanced inputs accommodate stereo line-level signals. These TRS (Tip-Ring-Sleeve) ¼" jacks handle either balanced or unbalanced signals. In most cases an unbalanced signal may use a mono ¼" plug (Tip-Sleeve). See the Sound System Interconnection RaneNote included with this manual for proper connection. These balanced XLR's provide the A and B mixed output. INTERNAL OUTPUT LEVEL switches allow setting the output level for MIC or LINE level. Pin connections are the same as above in 1. 6 Power connector: The internal universal switching power supply operates on any AC mains 100 to 240 VAC, 50 or 60 Hz (most places in the world). All that is required when traveling is the appropriate IEC line cord. Manual- OPERATING INSTRUCTIONS MONO MICROPHONE/LINE LEVEL INPUTS 1-4 The microphone pre-amps in the MLM 82S have a combination gain trim, Level control. The LEVEL control adjusts both the input dynamic range and mix level. There is no need for the typical independent gain trim control found on most mixers. [. . . ] A single mono input may be used for the A and/or B inputs. Any mono source connected to A will go to the A output. Any mono source connected to the B input will go to the B output. If you wish one or two mono sources to go to both A and B outputs, press the MONO switch. [. . . ]