User manual RANE MP 2

[. . . ] The only Level controls that affect all Outputs simultaneously are the PGM A and B LEVEL controls. If you bring a phono signal into P1 or P2 be sure to keep the PHONO switch in; likewise when connecting a CD player to this input, be sure the PHONO switch is out. Start with the HOUSE LEVEL all the way down so you don't scare the neighbors. Start with the Crossfader all the way to the left (PGM A). [. . . ] When it's all the way right, only Program B is heard. When it's right in the middle, both Program A and B are mixed together equally. This is an Active CrossfaderTM which uses a VCA to deliver an extended life and reduced travel noise, but to insure trouble-free operation, see Fader Cleaning on page Manual-4. 7 HOUSE LEVEL control: Adjusts the Output Levels of the MAIN OUTPUTS. 8 Phone CUE switches: Select Program A or B in any combination. The associated yellow indicator lights when a CUE is activated and pressed in. Depressing a button sends PGM signals to the CUE side of the PAN control. For example, when the Crossfader is to the left (playing PGM A to the House), listen to CUE B (PGM B) on the headphones to audition, match beats or prepare its starting point. 9 Phone PAN control: Changes the relative levels of the Cue and Program mixed together in stereo for the headphones. PGM follows the Main (House) Output; Cue is determined by the CUE switches and only goes to the headphones. Adjust this control anywhere between Program and Cue. 0 PHONE LEVEL and headphone jack: As you guessed, plug your headphones in here and adjust the overall volume with the LEVEL control. q POWER indicator: Illuminates to let you know that the MP 2 is plugged in and ready to go. Manual- REAR PANEL DESCRIPTION 2 POWER MADE IN U. S. A. ACN 001 345 482 600mA CLASS 2 EQUIPMENT 3 MP 2 HOUSE 4 AUX 6 L R TAPE OUTPUT L2 MIC TO TAPE NO YES 7 L PHONO GROUND BALANCED OUTPUTS: TIP = (+), RING = (­), SLEEVE = SIGNAL GROUND L R P2 LINE PHONO BALANCED MIC INPUT LEVEL RIGHT LEFT RIGHT LEFT R L1 P1 LINE PHONO MIC 1 5 8 9 1 POWER input connector: This is not a telephone jack!Connect an 18 volt AC center-tapped transformer only. Use only a Rane model RS 1, shipped with the unit, or other compatible power supply approved by Rane. 2 Chassis ground point: This screw is provided for connection to chassis ground if required. 3 HOUSE OUTPUT: The front panel HOUSE LEVEL control affects the volume at this Output. These balanced ¼" TRS (tipring-sleeve) Outputs connect to a balanced equalizer or amplifier. Though not recommended, unbalanced ¼" TS (tip-sleeve) cables may be used for short runs (under 3 meters [10 feet]) to an amplifier with unbalanced inputs. See the RaneNote "Sound System Interconnection" for wiring recommendations. 4 AUX OUTPUT: This delivers the same signal as the HOUSE OUTPUT, but has its own LEVEL control on the rear panel. [. . . ] Remove the fader screws from the front panel. Draw fader assembly out through the bottom. Attach ribbon cable to new fader, screw onto front panel and replace bottom cover. Hold the fader assembly away from the mixer. [. . . ]