User manual RANE MP 22X

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual RANE MP 22X. We hope that this RANE MP 22X user guide will be useful to you.

Lastmanuals help download the user guide RANE MP 22X.


Mode d'emploi RANE MP 22X
Download

You may also download the following manuals related to this product:

   RANE MP 22X SCHEMA (336 ko)
   RANE MP 22X DATASHEET (390 ko)

Manual abstract: user guide RANE MP 22X

Detailed instructions for use are in the User's Guide.

[. . . ] OPERATORS MANUAL MP 22x DJ MIXER QUICK START If you won't read the manual (we know how it is) here are a few basic "plug it in and get signal thru it" facts. The MP 22x has all unbalanced RCA connectors, except for the XLR & ¼" Mic Inputs, ¼" Mic Loop, and the balanced ¼" TRS Master Outputs. Be sure your amplifier is off while making connections. On the front panel, set all controls to the middle of their travel. [. . . ] Order CaiLube MCL® from: CAIG Laboratories, Inc. Poway, CA 92064 Phone 619-486-8399 Fax 619-486-8398 Web www. caig. com REPLACING THE ACTIVE CROSSFADER The Crossfader may be removed from the front of the MP 22x without any disassembly of the unit itself, and may be performed while the unit is operating with no interruption of the audio signal. Remove the two (2) outer screws attaching the crossfader assembly to the front panel. Firmly pull the Crossfader Assembly forward, unplugging it from the connector on the bottom board. Install the replacement assembly by reversing the above instructions. Manual-3 REAR PANEL DESCRIPTION 1. REMOTE MIC/LINE INPUT: This ¼" tip-sleeve Input is for wireless mics or other high-impedence sources. MICROPHONE LOOP jacks: These ¼" tip-sleeve connectors are for inserting external signal processing in the microphone circuit only. These jacks do not effect the other Inputs. PHONO GROUND screw: This can facilitate your hum chasing, buzz eliminating experiments, providing a place to connect those extra wires coming out of the turntables. PHONO/LINE 1 & 2 INPUTS: These stereo Inputs are switchable from a PHONO (RIAA) stage for magnetic cartridges to a LINE level Input suitable for any line level device such as a CD player. Each Input may be adjusted with its TRIM control for level matching purposes if desired. LINE 3, 4, 5 & 6 INPUTS: These stereo pairs of RCAs connect LINE level Inputs only. Each Input may be adjusted with its TRIM control for level matching purposes if desired. MASTER LOOP SEND & RETURN: These stereo pairs of RCA connectors are for inserting external signal processing in the Master, Zone and Headphone circuits. This feature does not affect the operation of the MIC or AUX INPUTS. These are switching jacks--always finish the loop when connecting send or return. Only connect to a device that is capable of returning signal back to the MP 22x. AUX LINE INPUT: This stereo pair of RCA connectors is an extra set of LINE level Inputs with an independent front panel LEVEL control (see #7, Front Panel). TAPE OUTPUT: These RCA connectors are line level Outputs intended for use with a tape recorder, but not necessarily restricted to that purpose. These Outputs are not affected by the MASTER LEVEL fader. MIC & AUX TO TAPE OUT switch: In the YES position the Mic and Aux signals along with all Inputs are routed to the TAPE OUTPUT. In the NO position only program material from Inputs 1 through 6 appear at the TAPE OUTPUT. [. . . ] With the STEREO/MONO switch down, you get Mono Cue in the Left ear and Mono Program in the Right, and PAN controls the amount of each. With this switch up, you get Stereo Program in both ears or Stereo Cue in both ears, depending on the rotation of the PAN control. The overall volume is then controlled by the HEADPHONE LEVEL control. When a CUE is active at either Input Channel, and if the Meter CUE/PROGAM switch is down, the monoed Cue signal is routed to the LEFT side of the PEAK dBu Meter, while monoed Program is displayed on the RIGHT. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE RANE MP 22X

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual RANE MP 22X will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag