User manual RANE MP 2S

[. . . ] The only Level controls that affect all Outputs simultaneously are the PROGRAM A and B LEVEL controls. If you bring a phono signal into P1 or P2 be sure to keep the PHONO switch in; likewise when connecting a CD player to this input, be sure the PHONO switch is out. Start with the HOUSE LEVEL all the way down so you don't scare the neighbors. Start with the Crossfader all the way to the left (PROGRAM A). [. . . ] When the Crossfader is all the way left, only Program A is heard. When it's all the way right, only Program B is heard. When it's right in the middle, both Program A and B are mixed together equally. This is an Active CrossfaderTM which uses a VCA to deliver an extended life and reduced travel noise. To insure trouble-free operation, see Fader Cleaning on page Manual-4. 7 HOUSE LEVEL control: adjusts the Output Levels of the MAIN OUTPUTS. 8 Phone CUE switches: select Program A or B in any combination. The associated yellow indicator lights when a CUE is activated and pressed in. Depressing a button sends Program to the CUE side of the PAN control. For example, when the Crossfader is to the left (playing Program A to the House), listen to CUE B (Program B) on the headphones to audition, match beats or prepare its starting point. 9 Phone PAN control: changes the relative levels of the Cue and Program mixed together in stereo for the headphones. PGM follows the Main (House) Output; Cue is determined by the CUE switches and only goes to the headphones. Adjust this control anywhere between Program and Cue. 0 PHONES LEVEL and headphone jack: As you guessed, plug your headphones in here and adjust the overall volume with the LEVEL control. q POWER indicator: illuminates to let you know that the MP 2S is plugged in and ready to rock. Manual- REAR PANEL DESCRIPTION 4 100-240 V 50/60 Hz 7 WATTS 5 AUX , RING = , SLEEVE = SIGNAL GROUND 7 L R TAPE OUTPUT L2 MIC TO TAPE NO YES 2 L PHONO GROUND MP 2S COMMERCIAL AUDIO EQUIPMENT 24TJ R ACN 001 345 482 RANE CORP. MADE IN U. S. A. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. HOUSE BALANCED OUTPUTS: TIP = L R P2 LINE PHONO BALANCED MIC INPUT LEVEL RIGHT LEFT RIGHT LEFT R L1 P1 LINE PHONO MIC 8 6 1 3 1 PHONO/LINE 1 & 2 INPUTS: are switchable from a PHONO (RIAA) stage for magnetic cartridges (PHONO, switch in) to a LINE level Input suitable for any line level device such as a CD player (LINE, switch out). The PHONO GROUND screw connects to those extra green wires coming out of the turntables. 2 LINE 1 & 2 INPUTS: connect to stereo sources such as CD players or any line-level device. L1 and L2 may be assigned to Program A or Program B via the front panel INPUT switches. 3 MIC Input: accepts a ¼" balanced (TRS) or unbalanced (TS) microphone cable, controlled by the MIC LEVEL control on the front panel. 4 HOUSE OUTPUT: The front panel HOUSE LEVEL control affects the volume at this Output. [. . . ] Remove the fader screws from the front panel. Draw fader assembly out through the bottom. Attach ribbon cable to new fader, screw onto front panel and replace bottom cover. Hold the fader assembly away from the mixer. [. . . ]