User manual RANE VR 1

[. . . ] DATA SHEET / MANUAL VR 1 VOLUME REMOTE Description MP 44 Use The MP 44's REMOTE LEVEL port provides a means to control the level of the MASTER mix from a remote location. Applications include "gain riding" DJs, setting a comfortable listening level from a remote location and reducing the maximum available gain. DA 26 Use A port for a wired Remote Level control is provided for each of the six Outputs. [. . . ] Remote Mounting The VR 1 remote assembly mounts in a standard U. S. electrical box with a minimum depth of 2. 25" (5. 5 cm). Use the flat head #6 screws supplied with the kit to mount the remote assembly and silk-screened front panel to the electrical box. Install the knob so that the line on the knob is properly aligned with the silk-screening on the front panel of the remote. Install any Decora plate of your choice. For a secured installation, you may wish to leave the knobs off and use a blank Decora plate to cover the remote after adjustment. Euroblock Connections Be sure to note the wire color of each input in order to facilitate correct wiring to the controlled unit. If the ground or shield wire is left shorter, it acts as a strain relief for the other wires. Connect each wire to the 3-pin connector by fully inserting it in the correct socket and tightening the screw. Make sure wires are free of nicks and that the cable jacket is stripped back sufficiently to allow it to lie in the electrical box with the remote assembly inserted. GND Vc Vr LEVEL 4 2 0 10 6 8 Decora plate cover, not supplied. Wire Types Variations in wire type do not greatly affect the performance of the remote controls. However, 22-gauge stranded wire with a flexible jacket is recommended. You may use 3-conductor unshielded remote control signal cable for shorter runs (less than 200 feet) or 2-conductor (1 pair) shielded remote control signal cable (use the shield as the GND return) for longer runs (200 to 1000 feet). The type of wire required is influenced by your installation and local electrical codes. Rane Corporation does not provide or source cable. [. . . ] # 88741 Shielded remote control signal cable CAT. # 88723 GND Vc CW 2k RD Vr VR 1 Block Diagram and Schematic ©Rane Corporation 10802 47th Ave. W. , Mukilteo WA 98275-5098 TEL 425-355-6000 FAX 425-347-7757 WEB www. rane. com All features & specifications subject to change without notice. [. . . ]