User manual RAYMARINE AUTOHELM 6000 POWER PILOT

[. . . ] Distributed by Any reference to Raytheon or RTN in this manual should be interpreted as Raymarine. The names Raytheon and RTN are owned by the Raytheon Company. Installation & Operating Handbook Nautech Limiied, Anchorage Park, Portsmouth Hampshire, PO3 STO, England. Telephone (0705) 693611, Telex 86384 NAUTEC G. CONTENTS Page 2 3 3 3 4 4 4 5 5 5 6 7 7 9 10 11 12 13 13 14 14 15 17 17 18 18 19 20 21 21 21 21 22 23 23 24 25 25 1. 1. 1. 1 1. 1. 2 1. 1. 3 1 . 1. 4 1. 1. 5 1 . 1. 6 1. 2 1. 2. 1 1. 2. 2 General Description Course Computer Control Unit Fluxgate Compass RuddepReference Transducer Auxiliary Alarm Radio Navigation Interface Hydraulic Drive Units Type 0 Hydraulic Drive Type 1 Hydraulic Drive 6. [. . . ] If permanent rudder off-set is not applied to restore balance the vessel will bear on to a new heading. Under these circumstances the Autohelm PowerPilot detects that the original course is not being restoredand continues to apply additional rudder off-set in the appropriate direction until the vessel returns to the original heading. Automatic trimming capability ensures that the originally set course is held irrespective of any changes in balance that may occur during the course of a passage. Autohelm PowerPilot's central computer also continuously monitors the pattern of applied rudder correction and can distinguish unnecessary repetitive corrections caused by pitch and roll of the 1 J vessel from those necessary to maintain the selected heading. If unnecessary repetitive corrections continue the computer will automatically neglect them so that autopilot activity and power consumption is continuously optimised at minimum levels. The high degree of control automation made possible by the system's central micro computer simplifies user control to a series of push button operations. ELECTRONIC POWER SUPPLY 22 Fig. CIRCUIT BREAKER 25AMP- 12V H E A V Y DUTY POWER SUPPLY OUTPUT TO MOTOR 16 17 3. 2. 3 Operating Mode indication and Course Display The operating mode of the autopilot is indicated by a flashing red LED, as summarised below:- 3. 2. 4 Off-Course Alarm When the autopilot is set to Auto mode a built in off-course alarm is automatically set up. The off-course alarm will sound from all control units when the vessel deviates for any reason from the original course by more than 15" for over 20 seconds. If an auxiliary alarm is fitted this will also be sounded after a one minute delay to allow the watchkeeper to take corrective action. The alarm will be silenced if the vessel returns to within 1 So of the original course. If the vessel does not return within course limits the alarm can only be silenced by disengaging the autopilot and resetting a new course. f$j l If the rudder immediately drives hard over to port, the motor connections between the course computer and drive unit should be reversed. l If the rudder drives a few degrees to port, reverse the motor connections, and reverse the red and green wires of the rudder reference transducer. Reversal of the motor connections should be permanently made at one of the main terminal blocks and not by reversing the spade connector flying leads to the course computer. OPERATING MODE LED FLASHING CODE 3. 3. 2 Functional Test Procedure l STAND BY Autopilot switched on but not engaged )j y?J 3. 3 FUNCTIONAL TEST PROCEDURES The following functional tests and set up procedures must be carried out before sea trials are attempted. AU-t-0 Autopilot engaged to steer compass heading 3. 3. 1 Setting Up ~~@j~fzJjj@ Switch On Switch on the electrical supply from the main panel. All control units will emit a short beep tone to indicate that the computer is now active. The autopilot will start up in Stand By mode. L; Operating Sense The operating sense of the autopilot can be checked as follows:* Select Auto l Select + 10 which should move the rudder a few degrees to produce a turn to starboard. If this does not occur, correct operating sense can be restored as follows:* If the rudder immediately drives hard over to starboard, the red and green wires of the rudder reference transducer should be reversed in the connector unit. MANUAL Hand held control power steering in operation ii@ ON 0 OFF SECONDS ' ! : : : : Switch on and note that all control units are live and signalling Stand by mode. 0 Key Auto on any fixed control unit and note that Auto mode is indicated on all control units. l Key course change commands from all control units noting that corresponding helm movements occur. 0 Key Manual on the hand held control unit (if fitted) and note that Manual mode is signalled from all control units. l Key power steer commands via the course control keys of the hand held control unit and note that corresponding incremental helm movements occur. l Key Stand by The automatic trimming capability of the autopilot can be observed by the following test: Key Auto followed by a 1 O" course change to starboard. [. . . ] Please contact your nearest Service Centre for assistance. Always have ready:* Your Warranty Card l Proof of Purchase 28 29 9. SERUICECENTRES - UK, Eireand Channel Islands Greenham Marine Ltd 190 Dock Street Fleefwocd 03917 5241 Northern Ireland Belfast Lough Marine Electronics 55 aelfan Road Cnickfergur Co Antrim 0960365565 Humberside i/&m Electronicc Marine Ltd &`WM Wrlghl0cck. s Hull 0482 25163 , && &;i;;`%$e Ltd Grkgewalk Wroxham Norfolk 06053 2238 R 6 J Marine Electronics 2 alrch Avenue Dcwxoun ady Harwlch 0255 502819 R 6 J Marine Electronics c/o Suffolk Yacht Hdrbour Levington Iprwich 047 388 737 . A E s s e x Mantrbrite htarine Electronics dff 19d Spatal Road Maldon ESSex 0621 53003 Heron Marine Services 129 aroddway dbKent Herne say Kent 0227 361255 10. OVERSEASREPRESENTATIVES Ponsmo;th Hdmphwe 0705 693611 PortsmouthlChichester Harbour Greenham Marine Ltd EmrwonhYacht Harbour Thaney Road Emsworth Hampshire 0243378314 Chlchesrer Marina Chichester COXKk Pfymwth 0752 228114 Marine Electronics Sflemr Putiige auckfdnd arwer aideford Norlh Own 0805 22870 Ocean Marine Servicer 4 3 afetonride Pfymwth 0752 23922 Quay Electrfcs The Sail Loh Pump seeet arixham 080 45 3030 (Teignmouth) Ltd Argentina Trimer S. A. de Ore 2030/40 1425 Buenos Aires Argrntma Tel: (010 54 I) 774 3728/4470 Telex: 007 33 23653 TRMER AR Australia Solo Marine Pty Ltd 11 Green Street RwerbyNSW2212 AUSl& T&(01061 2)7745255 Telex: M)7 71 127045 SOLMAR AA FIX: (010 61 2) 7745291 Werner Ober-Yachtelektronik A-6890 Lusrenau Relchrstrasx 38 Austria Tel: (0104315577 2419 Fax: (010 43) 5577 24195 Barbados C. O. [. . . ]