User manual RAYMARINE C70 DISPLAY INSTALLATION GUIDE

[. . . ] C-Series Display Installation Manual Document Number: 87020-3 Date: March 2006 Trademarks and registered trademarks Autohelm, HSB, Raymarine, RayTech, RayTech Navigator, Sail Pilot, SeaTalk and Sportpilot are registered trademarks of Raymarine Limited. Apelco is a registered trademark of Raymarine Holdings Limited (Registered in all major marketing territories). AST, Autoadapt, Auto GST, Autoseastate, Autotrim, Bidata, Marine Intelligence, Maxiview, On Board, Raychart, Raynav, Raypilot, Raystar, ST40, ST60, Seaclutter, Smart Route, Tridata and Waypoint Navigation are trademarks of Raymarine Limited. Navionics is a registered trademark of Navionics Company, Italy. [. . . ] Apply firm but even pressure to the bezel along the: · Outer edges - work from the sides upwards and then along the top edge, to ensure that it clips securely into position. · Inner edges - particularly along the chart card door edge, to ensure that the bezel sits flat. Check that all control buttons are free to operate. It is suggested that you use your thumb or forefinger in a circular motion to do this. Removing the front bezel To remove the front bezel: D7214_1 1. To prevent damaging your dash or placing undue strain on the trunnion bracket: · Trunnion mounted unit - unscrew and remove display from the mounting. · Flush mounted - protect your dash and proceed with caution. Place a flat-bladed screwdriver in the aperture at the top right of the bezel and gently twist it to release the top clips. 26 C-Series Displays Installation Manual 3. Working from this corner, free the clips along the top edge of the display, then work towards the bottom edge. Taking care to ensure that the control buttons pass through the bezel. Carefully free the locating clips at the bottom of the bezel by lowering it away from the unit - DO NOT USE A SCREWDRIVER FOR THIS AS IT WILL DAMAGE THE CLIPS. Remove the bezel from the display. 3. 3 Cables This section details how to instal and connect all the relevant cables to your C-Series Display: Siting and securing cables Please note the following: · All cables should be adequately secured, protected from physical damage and exposure to heat. Avoid running cables through bilges or doorways, or close to moving or hot objects. · Connectors should be protected from damage. If it proves necessary to pull cables through a bulkhead or deckhead using a cord, this should be attached several inches behind the connector. Do not attach a tie immediately behind or around the connector. · Where a cable passes through an exposed bulkhead or deckhead, a watertight feed-through should be used. · Secure cables in place using tie-wraps or lacing twine. Coil any extra cable and tie it out of the way. Connecting cables You will need to install and connect the following cables to ensure that your display functions correctly: · SeaTalk cable (if SeaTalk system connected). · NMEA cable (if third party equipment, NMEA multiplexer, fast heading sensor, RS232 interface or course computer fitted). · SeaTalk2 cable (if Sea Talk2 system connected). The cable connections are located on the back of the unit. If a trunnion bracket is being used, all cables can be connected prior to mounting the unit. [. . . ] My display switches off · Check power input connection is secure at the rear of the Display(s). · Check power cable for damage or corrosion. · Check your boat's power supply for faulty connections or insufficient cable diameter. Visit www. raymarine. com and click on Support to download the latest software. [. . . ]