User manual RAYMARINE HIGH DEFINITION ANTENNA CONTROL UNIT

[. . . ] Raymarine Satellite TV Systems - HD Antenna Control Unit User's Guide Document Number: 81285_1 Date: November 2006 Trademarks and registered trademarks Autohelm, HSB, Raymarine, RayTech, Sail Pilot, SeaTalk and Sportpilot are registered trademarks of Raymarine Limited. Apelco is a registered trademark of Raymarine Holdings Limited (Registered in all major marketing territories). AST, Autoadapt, Auto GST, Autoseastate, Autotrim, Bidata, Marine Intelligence, Maxiview, On Board, Raychart, Raynav, Raypilot, Raystar, ST40, ST60, Seaclutter, Smart Route, Tridata and Waypoint Navigation are trademarks of Raymarine Limited. DIRECTV is an official trademark of DIRECTV Inc. , a unit of GM Hughes Electronics. [. . . ] Connect the cables to the rear of the ACU. Using a pencil, mark the 4 hole positions (2 each side) for securing the mounting brackets. Using a suitable drill bit, drill the 4 holes in the required position. Using the screws supplied, secure the ACU into position. D7 953 _1 9 HD-ACU connection (no multiswitch) RF cable Power/Data cable RF1 4. Connect a 3 m RF cable from RECEIVER port on the rear panel of the HD-ACU to your Master IRD. Check that the power settings for each of the satellites (DTV101, DTV119, and DTV110) are set to AUTO - see "Power settings" below. IMPORTANT: The Master satellite receiver (IRD) must be HD capable, e. g. You will be able to view all HD programmes on the television set connected to this receiver. You can also connect a standard IRD to the RF2 port of the antenna baseplate, but you will not be able to view HD channels. FUSE POWER ANTENNA DC10. 8 - 15. 6V RF2 ANT. RF1 RECEIVER PC I NTERFACE HD-ACU Antenna baseplate Power settings When using DirecTV without a multiswitch, the power setting for each of the satellites (DTV101, DTV119, and DTV110) should be set to AUTO. This is the default setting on the HD-ACU. If you need to change the settings, this can be achieved in one of two ways: · · Using the PC program on the Installation CD. Manually change the power setting. IRD (not supplied) D9623_1 Using the PC program 1. Connect your PC to the HD-ACU using the serial cable provided. Open the folder named DirecTV without multiswitch. The new settings are sent to the antenna. The antenna is initialized using the new power settings. TV receiver(not supplied) To connect the HD-ACU: 1. Install the HD-ACU according to the instructions detailed on page 8. Connect one end of the Power/Data cable to the antenna baseplate, and one end to the ANTENNA port of the HDACU. Connect a 15 m RF cable from RF1 port on the antenna baseplate to ANT. RF1 port on the rear panel of the HD-ACU. 10 Raymarine Satellite TV Systems 5. Select the power supplying method ** to the LNB. NEXT - shows next method. Manually changing the settings POWER : AUTO PREV SETUP MODE?YES NO D7973_1 SELECT NEXT D7995_1 1. [. . . ] If an HD channel on DTV110# is requested, you will have to manually press the Sat B button on the HD-ACU. This will change the satellite pair to Sat B and Sat B*. As you change channels now you have the option to switch automatically between DTV101 and DTV110#. To return to the Satellite A pair, simply press the Sat A button on the HD-ACU. In the installation that uses a multi-switch, a DiSEqC supplier is required if three DirecTV satellites are used. [. . . ]