User manual RAYMARINE RAY 220 QUICK REFERENCE CARD

[. . . ] Rotate the Squelch knob slowly clockwise until the speaker noise "quiets". Press the [FUNC] then [1/25] key to set the power output to 1 watt or 25 watts as deemed appropriate. A 1 watt setting is generally recommended while in US harbors. Rotate the channel selector control or press the channel up/down switch on the microphone to select the desired operating channel. [. . . ] "l-" and "DSC" will be displayed. If another ships ID has been pre-programmed, the symbol will begin flashing on the display. Press [M1] to use the pre-programmed ID, or (see item "3. " below). To enter the Other Ship's ID: · Press [DSC], the displayed "l -" message will begin flashing. Select the first digit of the other ships ID using the channel selector knob, and press [DSC]. The "2 -" message will then begin flashing. · Continue entering the other ships ID in this manner until all 9 digits are entered. After the 9th digit has been entered, the ID number will be reviewed for your confirmation. When the ID has been successfully entered (using the [M1] key or manually), "- -" will appear on the LCD. Use the channel selector knob to select the channel you wish to communicate on and press [DSC]. If no channel is selected within 5 seconds, the unit will automatically default to CH16 (an alternate can still be selected). Momentarily press and release the PTT switch to transmit the call. When the targeted ship's station receives your transmission and acknowledges, "ACK" will display on the LCD and the unit will switch to the preset channel. With "CA" displayed on the LCD, rotate the channel selector knob until "Cd" is displayed, then press [DSC]. With "d - " and "DSC ON" displayed, press and release the PTT switch to transmit. If an appropriately equipped station receives your transmission and acknowledges, "ACK" will display on the LCD and the unit will switch to CH16. To receive DSC transmissions (CH70 must be selected): · When an Individual Ship's Call is received, the alarm will sound and the, "l -" message will flash. Press [FUNC] then [DSC] to cancel the alarm message, then press the PTT switch to acknowledge. The RAY220 will then switch to the channel specified in the transmitted message. · When an All Ship's Call is received, the alarm will sound and the, "A -" message will flash. Press [FUNC] then [DSC] to cancel the alarm, and the RAY220 will automatically switch to CH16 to monitor the all ships call message. · When a Distress Call is received, the alarm will sound and the, "d -" message will flash. [. . . ] Pressing the PTT switch will produce a continuous blast. To initiate Automatic foghorn mode, press [FUNC] then press and [FOG] for 3 seconds. "AUTOFOG" will display on the LCD and the unit will give a 5 second blast approximately every 115 seconds until canceled. To discontinue either foghorn operation, press [FUNC] then [FOG]. INTERCOM OPERATIONS To operate the Intercom: 1. [. . . ]