User manual RAYMOND WEIL QUARTZ WATCHES WITH ALARM FUNCTION

[. . . ] In order to guarantee the perfect functioning of your RAYMOND WEIL watch for many long years, we thank you to pay close attention to the advice contained in these Instructions for Use as well as in the International Guarantee booklet. CHANGING THE DATE AND SETTING THE TIME Your RAYMOND WEIL watch may be fitted with a WATCH HANDS W HOUR HAND MINUTE HAND SECONDS HAND screw-down crown. Before setting the time or changing the date, it is therefore necessary to unscrew the crown by pulling it straight out and turning it anti-clockwise. The crown will then be released by a spring. [. . . ] In order to set the time to the nearest second, pull the crown out to position 3 when the seconds hand points to 60. Then, push the crown back in to position 1 at the correct time to the nearest second (do this in conjunction with a radio signal or a radio-controlled clock, etc. ). SETTING CROWN PUSH-BUTTON: -ALARM FUNCTION SETTINGS -ALARM ACTIVATION/DEACTIVATION SMALL HOUR HAND SMALL MINUTE HAND DATE ALARM HANDS 1 Normal position and alarm time-setting 2 Rapid date change 3 Time-setting (current time and reference time) 1/2 After setting the time, always push the crown back in to position 1, in order to restart the hands and to preserve The current time is indicated by the hour and minute hands. your watch's water-resistance (the small counter display The reference time, which serves as the basis for the alarm changes from reference time to alarm time). A beep time, runs in the background, in parallel with the current indicates that the alarm is switched off. Thus, resetting the current time also necessitates an identical adjustment of the reference time. SETTING THE ALARM TIME With the crown in position 1, activate the setting mode If the reference time is not synchronized with the current by pressing the push-button for at least 2 seconds. This time, the alarm will go off at a different time from the mode is activated as soon as the small minute hand pre-set alarm time. In order to adjust the reference time, pull the crown out to position 3 (the small counter changes from alarm time to reference time) and activate the setting mode by pressing the push-button for at least 2 seconds. This mode is activated as soon as the small minute hand jumps forward 1 minute. - A short push (less than 1 second) advances the reference time in minute intervals. - A medium push (1 to 2 seconds) advances the reference time in hourly intervals. - A long push (more than 2 seconds) advances the reference time until the push-button is released. - A short push (less than 1 second) advances the alarm time in minute intervals. - A long push (more than 2 seconds) advances the alarm time until the push-button is released. The alarm time-setting mode deactivates itself if the push-button is not activated for 10 seconds. Simultaneously, 2 beeps indicate that the alarm is switched on. SETTING THE ALARM FUNCTION REFERENCE TIME ACTIVATION AND DEACTIVATION OF THE ALARM The alarm is activated or deactivated by a short pressing of the push-button (2 beeps signify alarm activated; 1 beep signifies alarm deactivated). [. . . ] In order to make the battery last longer, pull the crown out to position 3 whenever you do not intend to wear your watch for a while. Once exhausted, the battery should be replaced without delay, in order to avoid any risk of damage to the movement. Please have your watch battery changed only by an approved RAYMOND WEIL dealer. NOTICE Disposal of a watch by non-compliant methods may cause harm to the environment and is heav ily fined according to the regulations established by each one of the EU member countries in application of the Directive on Waste Electrical and Electronic Equipment (Directive 2002/96/EC WEEE). [. . . ]