User manual RCA 20F501TDV

[. . . ] TV/VCR/DVD User's Guide Changing Entertainment. Again. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS POLARIZED PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] To return to playback: Press PLAY or PAUSE/STILL. Adjusting tracking condition Automatic tracking adjustment Whenever you insert a tape and start playback, automatic tracking starts working and continuously analyzes the signal to enable optimum picture quality during playback. Manual tracking adjustment If automatic tracking cannot eliminate noises well during playback, press TRACKING +/ to eliminate the noises. Press it briefly for a fine adjustment, or press and hold for a coarse adjustment. Press ATR to reactivate automatic tracking again. NOTES: The audio output is muted during Picture Search, Still Picture, Frame by Frame Picture and Slow Motion. During picture search mode there will be noise bars which are caused by the system. The Special Playback will automatically change to playback after approx. 5 minutes to protect the video tape against excessive wear. To monitor a TV program Press TV MONITOR while in the playback mode. The video tape will continue to play while the picture switches to the TV channel selected on the TV/VCR/ DVD. Press the button to return to the playback picture. CM skip Press 30 Sec ADV in the PLAY mode. The TV/VCR/ DVD will search forward through approximately 30 seconds of the tape (e. g. unwanted commercial time) for each press of 30 Sec ADV (maximum six presses) and then resume normal playback. For example: 1 press: 30 second of tape 2 press: 60 second of tape 3 press: 90 second of tape 36 ZERO RETURN function / Video index search system ZERO RETURN function This function makes tape-rewinding stop at the counter 00:00:00 position automatically. Preparation: Press TV/VCR to select the TV/VCR mode. 1 Press DISPLAY/CALL. The counter display shows the tape running time during playback or recording. TV/VCR 8:40AM THU 00:30:50 SP 2 Press COUNTER RESET at the desired tape position. The counter display will be reset to the "00:00:00" position (e. g. the beginning of recording). TV/VCR 8:40AM THU 00:00:00 SP 3 Press STOP when playback or recording is finished. Press ZERO RETURN. The tape will be rewinded or fast forwarded and automatically stop at the "00:00:00" position. Video index search system This function enables you to locate the beginning of any recording made on the VCR. Recording an INDEX MARK The Index Search function automatically records an INDEX mark on the tape whenever a recording is initiated. INDEX CH 001 NOTES for Counter Display: If you rewind the tape beyond "00:00:00", a minus sign ("") will be displayed in front of the time. When you load a tape, the counter will reset to "00:00:00". The counter does not function on nonrecorded (blank) sections of the tape. When you rewind, fast forward or play tapes through blank sections, the counter stops. NOTES for Video index search system: When you record an INDEX mark at the very beginning of the tape, the mark may not be found. [. . . ] For rental firms, proof of first rental is also required. What your warranty does not cover: Customer instruction. (Your Owner's Manual describes how to install, adjust, and operate your television. Any additional information should be obtained from your dealer. ) Installation and related adjustments. Signal reception problems not caused by your unit. [. . . ]