User manual RCA LYRA RD1075

[. . . ] RD1021/1071 IB-EN 5/19/03 2:55 PM Page 1 FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation . This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Close the door of the battery compartment. Note: Refer to the power level indicator on display for battery level. Replace with new battery when the indicator is empty. Caution: Do not remove Memory Card during playback or when power is on. It may stop unit from playing immediately. 2 3 RD1021/1071 IB-EN 5/19/03 2:55 PM Page 10 Before You Begin 6. Using Headphones Insert phone jack into PHONES at the top of player for listening. General Controls 1. Insert the smaller end of the connection cable into the socket tightly. Insert the opposite end of the connecting cable to the USB socket on the back of the computer. Press "PLAY" button and "USB Connected" will be displayed on the device. 8 2 off MODE DSP 7. Connecting the Player to your Computer EN 10 7 6 5 Note: Have a Blast- Just Not in Your Eardrums. Make sure you turn down the volume on the unit before you put on headphones. Increase the volume to the desired level only after headphones are in place. 4 MODE DSP 9 2 3 last 4 next 1 on OPEN 1 stop play 3 Note: Refer to the Software Instruction manual for procedures in setting up USB drivers and transferring files to the player. 1. PLAY - Turn unit on, start playback and pause. STOP - Stop playback and turn unit off . Refer to the volume bar on display for sound level. P Song information P DSP mode Key Lock To avoid accidental key activation, slide the LOCK key to ON position to lock keys. Note: When the unit is in off mode and the HOLD key is in ON position, pressing PLAY key will cause display to show the key lock icon for three seconds. P Encoded bitrate USB connected To scroll the display information, press and hold the MODE button. 6 7 RD1021/1071 IB-EN 5/19/03 2:55 PM Page 14 General Operation DSP · Press repeatedly to select among the DSP modes: FLAT > BASS > POP > ROCK > JAZZ Advanced Operation Programming Tracks 1. Press and hold MODE for 2 seconds in stop mode to enter program mode. You will see `P' icon lit representing program mode, flashing ` - -' for track selection and `P01' for program list position. (If you have program in your player, the preprogrammed track number will be shown. Press Skip backward or Skip forward to select a track. Note: The player will enter Intro Play mode and play the beginning of each track as you scroll through tracks for programming. [. . . ] Limited Warranty Product Registration: Canadian Limited Warranty Thomson Multimedia Ltd. warrants to the purchaser or gift recipient that if any manufacturing defect becomes apparent in this product within 1 year from the original date of purchase, it will be replaced free of charge, including return transportation. This warranty does not include damage to the product resulting from accidents, misuse or leaking batteries. Should your product not perform properly during the warranty period, either: 1. [. . . ]