User manual RECARO BABYZEN

[. . . ] It provides a unique mobility solution for your child, from infancy (*) to toddlerhood. We wish you the most wonderful and fascinating outdoor experience with your baby and your new BABYZENTM stroller. This interactive user guide includes all necessary instructions, illustrated on a stand-alone drawing sheet. Read through it, and within a few minutes you will become familiar with your BABYZENTM stroller. [. . . ] In case of malfunction, this signal remains off. 3/10 CAUTION : always check seat and wheel frames are perfectly locked together, then pivot the stroller back on its wheels. Depending on version, the lighting system switches on automatically when unfolding the stroller, or must be switched on by pressing the ON/OFF button located under the wheeled frame central node. Installing the basket Insert the two elastic loops into the slots located at the back of the frame's central node, and fasten to the pins. Attach basket to frame by fastening together the snap buttons. Install the strap located under the basket by inserting it under the tie, so that brake cables are held against the bottom of the basket. Installing seat unit Zip up all zip fasteners on the backrest, and detach the seat touch fasteners. Insert the two backrest guide rods into the grooves located at the upper end of the frame, then slide down simultaneously to the bottom. Fully zip up the folding zip fasteners located on each side of the seat unit. 3 Seat unit components 1. Guide rods for the sides of the backrest. Rear hook for fastening seat unit in folded position. Elastic loops for fastening backrest folding zips. Elastic loops for fastening the seat to frame of the pushchair. Touch fastener strap for adjusting harness shoulder height. Hook for fastening seat unit in folded position. Harness crotch strap. 4 Push up the guide rod for the seat front into the groove located under the seat plate. Fasten the two elastic loops for the backrest folding zips around the reels located on each side of the handlebar pivots. Engage the three elastic for fastening the seat into the hooks located under the seat plate. Fasten the elastics of the straps to the hooks on each side of the foot rest. Installing the harness Slide the harness through the touch fastener strap on the backrest. CAUTION: you MUST (i) position the harness so that it has a V shape when you are facing the pushchair, and (ii) ensure that the touch fastener on the harness is in contact with the touch fastener inside the backrest strap. Slide the harness through the opening in the backrest cushion. 5 Harness and cushions 1. Elastic loops for fastening the backrest cushion 7. Opening for crotch strap Clip the connectors of the body straps. CAUTION: make sure the body straps are not twisted, and that you hear a CLICK when engaging each connector. [. . . ] To remove the car seat: Put the car seat handle in upright position, then press the two identical gray triggers located on each side of the seat, and lift off. 12 Lower the car seat handle (following the RECARO Young Profi Plus instruction manual). Installing the canopy Slide the two bows through the guides in the canopy fabric. Insert the loose ends of the bows into the lodgings of the canopy adapters, then attach the elastic loops to the reels. CLIPBOARDTM: with this accessory the BABYZENTM stroller can be installed inside a car trunk, by securing it at the back of the rear seats (when the rear seat is fractioned). To adjust the cord tension, pull it with one hand while using the other to tighten the hook, by pressing the two side buttons. CAUTION: to avoid any risk of strangulation, keep this item away from children. 13 The canopy offers two main service positions. Before folding the stroller with its canopy, pull down the canopy over the seat. Click the canopy adapters onto the connectors on the frame, until you hear the two CLICKS for locking. [. . . ]