User manual RECARO YOUNG PROFI

[. . . ] If you intend using the Isofix system then please check beforehand in your vehicle manual whether this size class is approved for your vehicle. To eliminate the rocking function fold the carrying handle over the head area until it locks in place. When the child is in the infant carrier the harness should be fastened at all times!This is only possible if the manufacturer has provided the car with an appropriate adapter. [. . . ] Removing the infant carrier: Press down the locking lever (A) to release the front locks and lift off the infant carrier. Push the infant carrier slightly towards the rear of the vehicle and lift out. If this proves to be difficult on account of collision with the vehicle’s rear seat, then readjust the Isofix base slightly forwards (see fig. 1 The Isofix base can be extended on it`s connectors by pressing the yellow buttons together and moving the Isofix base towards the front of the vehicle. This is necessary before any renewed installation in another vehicle. 2 Release the Isofix connectors by pulling the two unlocking buttons. 1 Insert the lap section of the seatbelt in the guides on both sides and close the belt locking buckle with an audible click. 2 Pull out the shoulder belt and place it around the head area of the infant carrier. 3 Insert the shoulder belt in the guide (see the blue routing arrow). 4 During transportation in the vehicle, the carrying handle must be in the upright position. 1 Pull the shoulder pads and belt locking buckle pad off the belts. 2 Pull the shoulder straps off the yoke plate. 3 Remove the headsupport and unbutton the sunshade. 4 Unhook the rubber loops and pull off the head support cover. 5 Unhook the rubber loops from the inside of the shell and remove the cover. Fasten the cover in the reverse sequence (see diagrams 10. Safety instructions: Ensure that the belt is correctly positioned at the load-absorbing points. The cars belt buckle must be located beneath the belt guide of the infant carrier when the belt is fastened. If the buckle is located above the belt guide of the infant carrier then the seat must not be used. 11 3992F-4-00/1 • The infant carrier is only suitable for use in approved vehicles fitted with automatic 3-point safety belts that conform with UN - ECE Regulation No. [. . . ] However, fabrics are bleached by UV radiation. This is not a material fault, merely normal wear for which no guarantee is given. € Locking buckle: Functional faults of the belt locking buckle are usually attributable to dirt for which no guarantee is given. Protecting your vehicle • We point out that the use of child seats may cause damage to the vehicle seats. [. . . ]