User manual RECARO YOUNG SPORT HERO

[. . . ] This unrivaled expertise feeds into the development of all of our child safety systems. Our aim is to offer you products which set new standards in terms of design, functionality, comfort and safety. selected materials , maximum precision in manufacturing and extensive test procedures ensure the highest quality and safety. With new ideas and innovative solutions we constantly strive to offer you the best products for life on the move with your children. [. . . ] 7729-4-00/1 9 DE EN Legen Sie die Gurte außen ab. Fasten the buckle by pushing the two tongues into one another (1) and inserting them into the buckle until it closes with an audible click (2). Tighten the straps by pulling the central belt in the direction indicated by the arrow. The straps should fit tightly to your child. Pull on the yellow ratchet stop button and raise the headrest to the next position. Before adjusting the headrest, check if the insert cushion needs to be removed for the child first. In the event of the insert cushion being removed, take care when feeding the buckle and crotch pad through. The shoulder straps should always be positioned as shown in the adjacent illustration. The straps should never follow a course below the child’s shoulders. 7908-00 / 1 The child seat can be placed in a rest position by turning the adjuster handle in the direction indicated by the arrow. Once the internal harness system has been removed (for use for group II and up), the recline position should no longer be used. The buckle must not be lubricated with oil or grease. The cover of the RECARO Young Sport Her∞ can be washed in the washing machine. We recommend washing the cover at 30 °C on a gentle wash setting in order to protect the environment. If washed at higher temperatures the colors may fade. Do not spin and never dry in a tumble drier, as the material and wadding could separate from one another. 7914-00 /1 First release the cover from the buttons on the head, back and seat sections. Removing the seat cover is only possible if the harness system has previously been removed (see chapter 3. Installation is made easier if the buckle tongues are locked in place in the buckle. First unclip the base plate and turn it away to the side. Then remove the seat cushion and place it to one side. Now insert the lap belt of the integral harness system from the top through the outer long slit and downwards, then thread it through the inner slits back towards the top (1). [. . . ] Attach the shoulder straps to the T section. Finally, close the shoulder pads and ensure, by pulling firmly on the straps, that all the connections are secure. 1 General information • The instructions for use are located in a pocket under the upholstery on the back of the seat. They should always be replaced after use. [. . . ]