User manual REMINGTON 1100

[. . . ] Owner's Manual Instruction Book for: Models 1100, 11-87 & Models 1100, 11-87 & 11-87 Super magnum 11-87 Super magnum Autoloading Shotguns Autoloading Shotguns Manual page 2 . . . . . . . . the ten commandments of firearm safety IMPORTANT! READ ALL INSTRUCTIONS AND WARNINGS IN THIS BOOK BEFORE USING THE FIREARM. page 7 . . . . . . . . important parts of the firearm page 11 . . . . . . how to load and unload page 16 . . . . . . lubrication and maintenance page 18 . . . . . . how to obtain parts and service A Tradition of Performance and Safety. In 1816 Eliphalet Remington was confident he could make a flintlock that was as good or better than any he could buy. The barrel he handcrafted set a new standard for firearm accuracy and spawned generations of products that have made Remington® Arms America's leading gunmaker. While performance and style are certainly hallmarks of Remington firearms, one factor ultimately drives their performance. Eliphalet Remington never lost sight of the fact that his rifles were potentially Eliphalet Remington's first lethal and could kill someone if handled improperly. [. . . ] Place the choke tube wrench into the choke tube. Turn the wrench counterclockwise and remove the choke tube. Select the desired choke tube and insert the tube into the barrel. Tighten the choke tube snugly but DO NOT OVER-TIGHTEN. With the bolt open and the chamber and magazine empty, check the choke tube occasionally to make sure it has not loosened. NOTE: NEVER fire the firearm without the choke tube installed. PICTURE 9 To Assemble (Model 1100TM) The Model 1100TM is shipped with the barrel assembly removed. See Picture 9 for location of parts. Gas Cylinder Collar Remove Wire Tie WARNING: MODEL 11-87TM BARRELS CAN NOT BE USED AS REPLACEMENT BARRELS ON MODEL 1100 FIREARMS. MODEL 1100 BARRELS CAN NOT BE USED AS REPLACEMENT BARRELS ON MODEL 11-87 FIREARMS. NOTE: The barrel and chamber should be cleaned before assembling the firearm. Clean the barrel following the instructions on page 16. Pull the operating handle fully rearward to open the action. Slide the fore-end forward and remove it from the magazine tube. Remove the cardboard packing ring from the magazine tube. Hold the barrel in front of the gas cylinder. Place the gas cylinder over the end of the magazine tube. Align the long slot on the rear of the barrel with the stud projecting from the inside of the receiver. NOTE: 28 & . 410 gauge barrels have short barrel extensions. Align the ejector slot in the end of the barrel with the ejector located inside the receiver. Do not jam the barrel against the ejector. Seat the barrel firmly into the receiver. Slide the fore-end over the magazine tube. Replace and tighten the magazine cap. PICTURE 10 PICTURE 11 FULLY ASSEMBLED MODEL 1100 (Model 1100 LT-20 Shown) 10 To Assemble (Model 11-87TM) WARNING: MODEL 11-87TM BARRELS CAN NOT BE USED AS REPLACEMENT BARRELS ON MODEL 1100 FIREARMS. [. . . ] · Enclose a letter with the firearm detailing the model name or number of your firearm and serial number along with a full description of the problem. Be sure to include your full name and address (P. O. Box and Street Address), including zip code, daytime telephone number and e-mail address. · Ship your firearm by either United Parcel Service (UPS) or Parcel Post (US Post Office). [. . . ]