User manual REMINGTON 572

[. . . ] Do not use while bathing or in the shower if it is plugged in. Do not store it in temperatures exceeding 140°F (60°C). Do not plug or unplug this appliance when your hands are wet. Do not wrap the cord around the appliance. Always attach the plug to the appliance, then to the outlet. [. . . ] This shaver can only be used cordless, do not have shaver plugged into outlet while shaving. It may take up to 3 cycles for the battery to reach full capacity. (A) (D) To Charge (B) (E) (F) Before using your shaver for the first time, charge it for 24 hours. Slide the ON/OFF button to the OFF position. Connect the cord to the shaver and then to the electrical outlet. The Charging Indicator light will glow green, indicating your shaver is charging. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. The 572 is designed for cordless operation only. Plugging in the cord will not provide the power to shave. (C) 4 5 29697_572_IB 8/25/06 3:57 PM Page 6 Usage Tips Getting a close, comfortable shave Remington® shavers need no adjustments to their heads or cutters before you shave. The heads will automatically adjust to the contours of your leg. As with every shaver, your shave will improve over time. So allow about three weeks to develop an effective shaving style and for your legs to adjust to the new shaver. You can also run your shaver under the faucet to rinse off the hairs. Never clean the shaver or replace the cutters while it is plugged into an electrical outlet. Do not clean or remove the head assembly while the shaver is running or plugged in, as it may cause damage to the unit's heads or cutters. Replace worn or damaged parts with Remington® replacement parts only. Important: Make sure to align the two locating holes in the Cutter Retainer assembly with the pins in the Head Frame Assembly. Then tighten center screw knob to lock the cutters into place. To Shave Slide the ON/OFF button up to activate the shaver for shaving. Hold the shaver so all the heads touch your leg together. This allows the shaver to work the way it was designed for the closest shave and minimum wear. Avoid holding the shaver at an angle so only one head touches the skin. This could cause skin irritation. When is it Time to Replace Your Heads and Cutters? It is very important to replace your heads and cutters when necessary to ensure a close, comfortable shave without irritation. We recommend they be replaced every 12 months. [. . . ] SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN DURATION TO TWO YEARS FROM DATE OF ORIGINAL PURCHASE. This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to province. Some states do not allow the exclusion or limitation of incidental, special or consequential damages. [. . . ]