User manual REMINGTON 700 ETRONX

[. . . ] Owner's Manual Instruction Book for: Model 700 EtronX Model 700 EtronX Bolt Action Centerfire Rifle Bolt Action Centerfire Rifle Manual page 2 . . . . . . . . the ten commandments of firearm safety IMPORTANT! READ ALL INSTRUCTIONS AND WARNINGS IN THIS BOOK BEFORE USING THE FIREARM. page 9 . . . . . . . . important parts of the firearm page 13 . . . . . . how to load and unload page 14 . . . . . . lubrication and maintenance page 17 . . . . . . how to obtain parts and service A Tradition of Performance and Safety. In 1816 Eliphalet Remington was confident he could make a flintlock that was as good or better than any he could buy. The barrel he handcrafted set a new standard for firearm accuracy and spawned generations of products that have made Remington® Arms America's leading gunmaker. While performance and style are certainly hallmarks of Remington firearms, one factor ultimately drives their performance. Eliphalet Remington never lost sight of the fact that his rifles were potentially lethal and could kill someone if handled improperly. [. . . ] Do not attempt to use your firearm. The Battery The Model 700TM EtronXTM uses a conventional 9-volt battery located under the recoil pad. For best all-around performance, Remington® recommends the use of an alkaline battery in the Model 700 EtronX. TO REMOVE AND INSTALL THE BATTERY: WARNING: Check the chamber and magazine to make sure there are no cartridges in the firearm. NEVER attempt to remove or install a battery on a loaded firearm. PICTURE 7 1. Put the safety mechanism in the S-SAFE position. Turn the key switch to the OFF/DISABLED (O) position. Using a Phillips screwdriver, loosen and remove both recoil pad screws and remove the recoil pad. Install the replacement battery as shown in Picture 7, making sure the + and - terminals on the battery match the corresponding terminal markings on the battery holder. Replace the recoil pad and tighten both recoil pad screws. Be careful not to overtighten the recoil pad screws. The Bolt Assembly The bolt assembly locks the cartridge into the chamber. TO INSTALL THE BOLT ASSEMBLY: WARNING: Check the chamber and magazine to make sure there are no cartridges in the firearm. NEVER attempt to install the bolt assembly on a loaded firearm. PICTURE 8 1. Put the safety mechanism in the S-SAFE position. Turn the key switch to the OFF/DISABLED (O) position. Align the lugs on the bolt assembly with the receiver. Slide the bolt assembly into the receiver and push all the way in. To place the bolt assembly in closed position, push the bolt handle down. 10 TO REMOVE THE BOLT ASSEMBLY: WARNING: Check the chamber and magazine to make sure there are no cartridges in the firearm. NEVER attempt to remove the bolt assembly on a loaded firearm. Put the safety mechanism in the S-SAFE position. Turn the key switch to the OFF/DISABLED (O) position. As you push the bolt stop release, slide the bolt from the firearm. Firearm Assembly and Disassembly TO DISASSEMBLE: WARNING: Check the chamber and magazine to make sure there are no cartridges in the firearm. NEVER attempt to assemble or disassemble the bolt assembly on a loaded firearm. [. . . ] Reassemble the firing pin and bolt following the instructions on page 16. · Return the firearm to the factory for service. Please note the condition in the letter of explanation accompanying the firearm when it is returned for service. · Firing pin insulator missing. · Firing pin is damaged. LED turns ON solid or flickers when bolt is moved. · Bolt touching trigger assembly contact. · Lift the bolt handle and pull the bolt partway back. [. . . ]