User manual REMINGTON 710

[. . . ] Remington introduces the Model 673TM centerfire rifle. The Model 673TM is made on the reliable Model SevenTM action. All instructions for the Model SevenTM apply to your Model 673TM with the following two exceptions: The Rear Sight Elevation Adjustment The Addition Of The Ventilated Rib. To Adjust The Rear Sight: WARNING: Always check the chamber and the magazine to make sure there are no cartridges in the firearm. [. . . ] Once the red dot is in place remove the key. THE SECURITY SYSTEM IN NOW DISENGAGED AND THE BOLT CAN BE CLOSED AND CAMMED INTO THE FIRING POSITION. To engage the security system, FIRST ENSURE THAT THE BOLT IS IN THE OPEN POSITION, then push the key into the "J'' slot. Once the key is in place turn it clockwise as far as it will go. From the rear of the firearm you will now see a WHITE dot. Once the white dot is in place remove the key. THE SECURITY SYSTEM IS NOW ENGAGED AND THE BOLT CANNOT BE CAMMED INTO THE FIRING POSITION. IMPORTANT: ISS will not lock the firearm unless engaged with the bolt open. Do not attempt to engage ISS when bolt is locked up. WHITE DOT PICTURE 7 In operating the security button, NEVER use excessive force to turn the key. If the key will not turn freely, contact a Remington® authorized repair center. Keep your security system engaged when your firearm is not in use. Keep your keys in a secure place, inaccessible to others. NEVER remove the trigger mechanism or make adjustments to the trigger or trigger assembly. NEVER put your finger on the trigger unless you are going to fire the firearm. The Barrel The inside of the barrel must be clean and free of obstructions. Put the safety mechanism in the `S' position. Remove any ammunition from the chamber or magazine. Look through the inside of the barrel from the chamber end to the muzzle. TO REMOVE OBJECT FROM INSIDE THE BARREL: 1. Push cleaning rod from the chamber end all the way through the barrel, until the rod comes out of the muzzle. If an object cannot be easily pushed out of the barrel with a cleaning rod, return the firearm to the factory or a REMINGTON RECOMMENDED GUNSMITH. NEVER try to remove an object from the barrel by loading another cartridge and firing. This may cause the barrel to burst or a cartridge case to rupture and cause serious personal injury. TO CLEAN THE BARREL FOLLOW THE INSTRUCTIONS SHOWN ON PAGE 12. [. . . ] Contact the Authorized Repair Center of your choice for evaluation of your firearm and/or additional shipping instructions. If your Remington Authorized Repair Center cannot provide the service or repair you require and you need further assistance, please call our toll free number 1-800-243-9700, Mon. -Fri. , 9:00 AM-5:00 PM Eastern time and select the option for repairs. Then, if shipment of your firearm is required, please: · Record the serial number of your firearm before sending it to us. · Pack your firearm for safety and to prevent further damage in shipping and handling. [. . . ]