User manual REMINGTON AQ7

[. . . ] Stretch the skin with your free hand so the hairs stand upright Only apply light pressure on the shaving head while shaving (pressing too hard can damage the heads and make them vulnerable to breakage). 2 AE HR/ SRB SL HOW TO USE GR RO TR RU HUN PL CZ SK 1 P FIN S DK I E F NL D GB 3 ENGLISH SHAVING WITH SHAVING GEL • Follow the same instructions as dry shaving if using with gel. CAUTION After use with shaving gel, please rinse the head and cutters under warm water to clean away any excess gel and debris. tIPS FOR THE BEST RESULTS Use moderate to slow stroking movements. [. . . ] The easiest and the most hygienic way to clean the appliance is by rinsing the product head after use with warm water. € • • • • • • IMPORTANT SAFETY INSTRUCTIONS WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS: • An appliance should never be left unattended when plugged in to a power outlet, except when charging. € Keep the power plug and cord away from heated surfaces. SERVICE AND GUARANTEE This product has been checked and is free of defects. We guarantee this product against any defects that are due to faulty material or workmanship for the guarantee period from the original date of consumer purchase. If the product should become defective within the guarantee period, we will repair any such defect or elect to replace the product or any part of it without charge, provided there is proof of purchase. 4 AE HR/ SRB SL GR MONTHLY Perform the daily cleaning steps first. Open the shaver head by pressing the release button on the front of the shaver and flipping open the head away from the body of the shaver. Release the inner cutter carrier by rotating the locking arms counter-clockwise. Pull the inner cutter carrier away from the inner cutters. Thoroughly brush hairs from the inner and outer cutters and rinse out remaining debris. Place the inner cutter carrier back onto the upper hairpocket and lock in place by rotating the locking arms clockwise until the arms ‘click’ into place. This shaver is a wet shaver, the hand-held part of which may be used in a bath or shower. BATTERY REMOVAL • • • • • • • • The battery must be removed from the appliance before it is scraped. The appliance must be disconnected from the supply mains when removing the battery. Remove headguard and hair pocket from shaver. Using a small screwdriver, pry off the front housing carefully. Using screwdriver remove (6) screws from front of shaver, and remove the rear housing. Pry the PCB assembly out of the shaver housing. Cut or break the wire stamps on both ends of the battery and remove the battery. [. . . ] If you call the Service Centre, please have the Model No. To hand, as we won’t be able to help you without it. It’s on the rating plate which can be found on the appliance. KOM GODT IGANG For en optimal barbering anbefales det at du bruger din nye barbermaskine dagligt i op til fire uger, for at give dit skæg og din hud mulighed for at vænne sig til det nye barberingssytem. [. . . ]