User manual REMINGTON BHT-2000

[. . . ] When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this appliance. To reduce the risk of burns, fire, electric shock or injury to persons: This appliance is for household use only. An appliance should never be left unattended when it's plugged in, except when charging a rechargeable appliance. [. . . ] removing the trimmer comb and cutting assembly Be sure trimmer is off. Hold the trimmer in one hand with your thumb firmly on the thumb wheel to keep it from turning. With your other hand, gently pull the trimmer comb attachment off the trimmer. Use your other hand to cover the cutting assembly to prevent accidents. removing the shaver attachment Ensure the trimmer is off. Hold the trimmer in one hand with your thumb firmly on the thumb wheel to keep it from turning. With your other hand, gently pull the shaver attachment off the trimmer. removing the shaver cover Ensure the trimmer is off. Gently push the buttons either side of the shaving foil. With the other hand lift the shaver cover. With your other hand, insert the lower part of the cutter assembly into the trimmer, push down the cutter until firmly attached. Replacing the trimmer comb and shaver attachment Hold the trimmer in one hand with your thumb firmly on the thumb wheel to keep it from turning. ensure that the length position indicator is at 1. Slide the comb/shaver down the grooves until it clicks into place. If it does not go on correctly, turn it around and try again. It's a good idea to begin trimming at one of the longest settings (4 or 5) to avoid accidentally trimming hair too short. As you become familiar with the settings, you can then select your desired length setting. place the flat top of the trimmer comb against the skin. If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull off the adjustable trimmer comb and brush/rinse it off. For an even closer look and precise shaping, remove the adjustable trimmer comb and trim the hairs along the outer edge. When you are finished, turn the trimmer off, clean it, and return it to its storage pouch. Adjusting the trim length The trimmer comb can be adjusted to give you 5 different trim lengths simply by by turning the thrmb wheel to the desired setting. [. . . ] Do not use harsh or corrosive cleaners on the unit or its cutters. Do not apply pressure or hard objects to cutters. Remove head and shake out the clippings Blow off cutter assembly. Replace head, making sure it snaps in place. [. . . ]