User manual REMINGTON CAPTURECUT PRO XF8705

[. . . ] 6 Suitable for use in a bath or shower. 7 Do not immerse the charging stand in water or any other liquid, nor rinse it under the tap. 8 Do not plug or unplug the appliance with wet hands. 9 Do not use the shaver, adaptor, charging stand or any other part if it is damaged, as this may cause injury. [. . . ] • The appliance adapts automatically to a mains voltage between 100V and 240V. € Quick charge feature: Your shaver is fitted with a 5 minute quick charge feature that will provide enough charge for 1 shave (3 minutes). f INSTRUCTIONS FOR USE , SHAVING • Make sure your shaver is properly charged. € Switch the shaver on by pressing the on/off switch. € Stretch the skin with your free hand so the hairs stand upright. € Hold the shaving head so that the foils touch your face. € Push the trimmer release button up to activate the trimmer. € Hold the trimmer at a right angle to your skin. 4 ENGLISH • To retract the trimmer, slide the trimmer release button down and push the back of the trimmer head downwards until it locks into place. E TIPS FOR BEST RESULTS • Always hold the shaver at right angles to the skin so that all foils are touching the skin with equal pressure. • Use moderate to slow stroking movements. The use of short circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line. € DO NOT press hard against the skin in order to avoid damage to the foil heads. , Note: your shaver has been designed to be used in the shower if desired. , CLEANING CAUTIONS • Remove the foil assembly by pressing the release buttons on either side of the head and lifting the foil assembly upwards to remove from the hair pocket. € Tap out the excess hair shavings and rinse the foils under running water. € Do not clean the shaving foil with a brush. € Replace the head assembly by placing the assembly on top of the hair pocket, press down and click into place. , CLEANING TRIMMER • Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil. , REPLACING THE FOILS & CUTTERS • To ensure continued high quality performance from your shaver, we recommend the foils and cutters are replaced every six months. , Signs that your foils and cutters need replacing. € Irritation: as foils get worn, you may experience skin irritation. [. . . ] € Cut the wire connecting the batteries to the circuit board and remove the batteries. • The battery is to be disposed of safely. 6 ENGLISH D To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled. 32 DANSK Tak for at have købt dit nye produkt fra Remington®. [. . . ]