User manual REMINGTON D2011DS PRO IONIC AC

[. . . ] For straight or hard to style hair – Use a blow-dry spray at the roots to create volume or throughout the lengths to create body, bounce and shine. Using the fast dry concentrator, remove excess moisture on medium heat/high speed setting. Start at the lower back and style hair section by section. For precision blow-drying use the slim concentrator. [. . . ] In use, take care that the inlet and outlet grilles are not blocked in any way as this will cause the unit to automatically stop. Should this occur, switch off and allow the unit to cool down. 10 22:01 ENGLISH GB Ensure the inlet grille is free from obstructions such as household fluff, loose hair etc. Do not place hairdryer on soft material e. Do not leave the dryer switched on when you set it down. Always ensure the voltage to be used corresponds to the voltage stated on the unit. Do not direct the airflow towards the eyes or other sensitive areas. Keep this product out of reach of children. The use of this appliance by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety should give explicit instructions or supervise the use of the appliance. Do not use any attachments with this hairdryer, other than those supplied by Remington®. Avoid allowing any part of the hairdryer to contact the face, neck or scalp. This appliance is not intended for commercial or salon use. If the supply cord of this unit becomes damaged, discontinue use immediately and return the appliance to your nearest authorised Remington® service dealer for repair or replacement in order to avoid a hazard. Special tools are required for any examination, adjustment or repair. Unqualified repair work could lead to hazardous conditions for the user. We do not accept responsibility for damage to the product, persons or other item(s), caused by misuse, abuse or non-compliance with these instructions. wIRING INSTRUCTIONS UK PLUGS ONLY This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace the plug fuse, use only fuses that are approved to BS1362, rated at 13A. [. . . ] The warranty shall apply in all countries in which our product was sold via an authorised dealer. This warranty does not include damage to the product by accident or misuse, abuse, alteration to the product or use inconsistent with the technical and/or safety instructions required. This warranty shall not apply if the product has been dismantled or repaired by a person not authorised by us. For further information and advice please contact: Customer Services Department. [. . . ]